2 files changed, 135 insertions, 0 deletions
diff --git a/Documentation/devicetree/bindings/soc/mediatek/pwrap.txt b/Documentation/devicetree/bindings/soc/mediatek/pwrap.txt
new file mode 100644
index 000000000..f9987c30f
--- /dev/null
+++ b/Documentation/devicetree/bindings/soc/mediatek/pwrap.txt
@@ -0,0 +1,64 @@
+MediaTek PMIC Wrapper Driver
+
+This document describes the binding for the MediaTek PMIC wrapper.
+
+On MediaTek SoCs the PMIC is connected via SPI. The SPI master interface
+is not directly visible to the CPU, but only through the PMIC wrapper
+inside the SoC. The communication between the SoC and the PMIC can
+optionally be encrypted. Also a non standard Dual IO SPI mode can be
+used to increase speed.
+
+IP Pairing
+
+on MT8135 the pins of some SoC internal peripherals can be on the PMIC.
+The signals of these pins are routed over the SPI bus using the pwrap
+bridge. In the binding description below the properties needed for bridging
+are marked with "IP Pairing". These are optional on SoCs which do not support
+IP Pairing
+
+Required properties in pwrap device node.
+- compatible:
+	"mediatek,mt2701-pwrap" for MT2701/7623 SoCs
+	"mediatek,mt6797-pwrap" for MT6797 SoCs
+	"mediatek,mt7622-pwrap" for MT7622 SoCs
+	"mediatek,mt8135-pwrap" for MT8135 SoCs
+	"mediatek,mt8173-pwrap" for MT8173 SoCs
+- interrupts: IRQ for pwrap in SOC
+- reg-names: Must include the following entries:
+  "pwrap": Main registers base
+  "pwrap-bridge": bridge base (IP Pairing)
+- reg: Must contain an entry for each entry in reg-names.
+- reset-names: Must include the following entries:
+  "pwrap"
+  "pwrap-bridge" (IP Pairing)
+- resets: Must contain an entry for each entry in reset-names.
+- clock-names: Must include the following entries:
+  "spi": SPI bus clock
+  "wrap": Main module clock
+- clocks: Must contain an entry for each entry in clock-names.
+
+Optional properities:
+- pmic: Using either MediaTek PMIC MFD as the child device of pwrap
+  See the following for child node definitions:
+  Documentation/devicetree/bindings/mfd/mt6397.txt
+  or the regulator-only device as the child device of pwrap, such as MT6380.
+  See the following definitions for such kinds of devices.
+  Documentation/devicetree/bindings/regulator/mt6380-regulator.txt
+
+Example:
+	pwrap: pwrap@1000f000 {
+		compatible = "mediatek,mt8135-pwrap";
+		reg = <0 0x1000f000 0 0x1000>,
+			<0 0x11017000 0 0x1000>;
+		reg-names = "pwrap", "pwrap-bridge";
+		interrupts = <GIC_SPI 128 IRQ_TYPE_LEVEL_HIGH>;
+		resets = <&infracfg MT8135_INFRA_PMIC_WRAP_RST>,
+				<&pericfg MT8135_PERI_PWRAP_BRIDGE_SW_RST>;
+		reset-names = "pwrap", "pwrap-bridge";
+		clocks = <&clk26m>, <&clk26m>;
+		clock-names = "spi", "wrap";
+
+		pmic {
+			compatible = "mediatek,mt6397";
+		};
+	};
diff --git a/Documentation/devicetree/bindings/soc/mediatek/scpsys.txt b/Documentation/devicetree/bindings/soc/mediatek/scpsys.txt
new file mode 100644
index 000000000..d6fe16f09
--- /dev/null
+++ b/Documentation/devicetree/bindings/soc/mediatek/scpsys.txt
@@ -0,0 +1,71 @@
+MediaTek SCPSYS
+===============
+
+The System Control Processor System (SCPSYS) has several power management
+related tasks in the system. The tasks include thermal measurement, dynamic
+voltage frequency scaling (DVFS), interrupt filter and lowlevel sleep control.
+The System Power Manager (SPM) inside the SCPSYS is for the MTCMOS power
+domain control.
+
+The driver implements the Generic PM domain bindings described in
+power/power_domain.txt. It provides the power domains defined in
+- include/dt-bindings/power/mt8173-power.h
+- include/dt-bindings/power/mt6797-power.h
+- include/dt-bindings/power/mt2701-power.h
+- include/dt-bindings/power/mt2712-power.h
+- include/dt-bindings/power/mt7622-power.h
+
+Required properties:
+- compatible: Should be one of:
+	- "mediatek,mt2701-scpsys"
+	- "mediatek,mt2712-scpsys"
+	- "mediatek,mt6797-scpsys"
+	- "mediatek,mt7622-scpsys"
+	- "mediatek,mt7623-scpsys", "mediatek,mt2701-scpsys": For MT7623 SoC
+	- "mediatek,mt7623a-scpsys": For MT7623A SoC
+	- "mediatek,mt8173-scpsys"
+- #power-domain-cells: Must be 1
+- reg: Address range of the SCPSYS unit
+- infracfg: must contain a phandle to the infracfg controller
+- clock, clock-names: clocks according to the common clock binding.
+                      These are clocks which hardware needs to be
+                      enabled before enabling certain power domains.
+	Required clocks for MT2701 or MT7623: "mm", "mfg", "ethif"
+	Required clocks for MT2712: "mm", "mfg", "venc", "jpgdec", "audio", "vdec"
+	Required clocks for MT6797: "mm", "mfg", "vdec"
+	Required clocks for MT7622: "hif_sel"
+	Required clocks for MT7622A: "ethif"
+	Required clocks for MT8173: "mm", "mfg", "venc", "venc_lt"
+
+Optional properties:
+- vdec-supply: Power supply for the vdec power domain
+- venc-supply: Power supply for the venc power domain
+- isp-supply: Power supply for the isp power domain
+- mm-supply: Power supply for the mm power domain
+- venc_lt-supply: Power supply for the venc_lt power domain
+- audio-supply: Power supply for the audio power domain
+- usb-supply: Power supply for the usb power domain
+- mfg_async-supply: Power supply for the mfg_async power domain
+- mfg_2d-supply: Power supply for the mfg_2d power domain
+- mfg-supply: Power supply for the mfg power domain
+
+Example:
+
+	scpsys: scpsys@10006000 {
+		#power-domain-cells = <1>;
+		compatible = "mediatek,mt8173-scpsys";
+		reg = <0 0x10006000 0 0x1000>;
+		infracfg = <&infracfg>;
+		clocks = <&clk26m>,
+			 <&topckgen CLK_TOP_MM_SEL>;
+			 <&topckgen CLK_TOP_VENC_SEL>,
+			 <&topckgen CLK_TOP_VENC_LT_SEL>;
+		clock-names = "mfg", "mm", "venc", "venc_lt";
+	};
+
+Example consumer:
+
+	afe: mt8173-afe-pcm@11220000 {
+		compatible = "mediatek,mt8173-afe-pcm";
+		power-domains = <&scpsys MT8173_POWER_DOMAIN_AUDIO>;
+	};