1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
|
Integrated Flash Controller
Properties:
- name : Should be ifc
- compatible : should contain "fsl,ifc". The version of the integrated
flash controller can be found in the IFC_REV register at
offset zero.
- #address-cells : Should be either two or three. The first cell is the
chipselect number, and the remaining cells are the
offset into the chipselect.
- #size-cells : Either one or two, depending on how large each chipselect
can be.
- reg : Offset and length of the register set for the device
- interrupts: IFC may have one or two interrupts. If two interrupt
specifiers are present, the first is the "common"
interrupt (CM_EVTER_STAT), and the second is the NAND
interrupt (NAND_EVTER_STAT). If there is only one,
that interrupt reports both types of event.
- little-endian : If this property is absent, the big-endian mode will
be in use as default for registers.
- ranges : Each range corresponds to a single chipselect, and covers
the entire access window as configured.
Child device nodes describe the devices connected to IFC such as NOR (e.g.
cfi-flash) and NAND (fsl,ifc-nand). There might be board specific devices
like FPGAs, CPLDs, etc.
Example:
ifc@ffe1e000 {
compatible = "fsl,ifc", "simple-bus";
#address-cells = <2>;
#size-cells = <1>;
reg = <0x0 0xffe1e000 0 0x2000>;
interrupts = <16 2 19 2>;
little-endian;
/* NOR, NAND Flashes and CPLD on board */
ranges = <0x0 0x0 0x0 0xee000000 0x02000000
0x1 0x0 0x0 0xffa00000 0x00010000
0x3 0x0 0x0 0xffb00000 0x00020000>;
flash@0,0 {
#address-cells = <1>;
#size-cells = <1>;
compatible = "cfi-flash";
reg = <0x0 0x0 0x2000000>;
bank-width = <2>;
device-width = <1>;
partition@0 {
/* 32MB for user data */
reg = <0x0 0x02000000>;
label = "NOR Data";
};
};
flash@1,0 {
#address-cells = <1>;
#size-cells = <1>;
compatible = "fsl,ifc-nand";
reg = <0x1 0x0 0x10000>;
partition@0 {
/* This location must not be altered */
/* 1MB for u-boot Bootloader Image */
reg = <0x0 0x00100000>;
label = "NAND U-Boot Image";
read-only;
};
};
cpld@3,0 {
#address-cells = <1>;
#size-cells = <1>;
compatible = "fsl,p1010rdb-cpld";
reg = <0x3 0x0 0x000001f>;
};
};
|
