1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
|
STMicroelectronics STM32 / MCU DWMAC glue layer controller
This file documents platform glue layer for stmmac.
Please see stmmac.txt for the other unchanged properties.
The device node has following properties.
Required properties:
- compatible: For MCU family should be "st,stm32-dwmac" to select glue, and
"snps,dwmac-3.50a" to select IP version.
For MPU family should be "st,stm32mp1-dwmac" to select
glue, and "snps,dwmac-4.20a" to select IP version.
- clocks: Must contain a phandle for each entry in clock-names.
- clock-names: Should be "stmmaceth" for the host clock.
Should be "mac-clk-tx" for the MAC TX clock.
Should be "mac-clk-rx" for the MAC RX clock.
For MPU family need to add also "ethstp" for power mode clock and,
"syscfg-clk" for SYSCFG clock.
- interrupt-names: Should contain a list of interrupt names corresponding to
the interrupts in the interrupts property, if available.
Should be "macirq" for the main MAC IRQ
Should be "eth_wake_irq" for the IT which wake up system
- st,syscon : Should be phandle/offset pair. The phandle to the syscon node which
encompases the glue register, and the offset of the control register.
Optional properties:
- clock-names: For MPU family "mac-clk-ck" for PHY without quartz
- st,int-phyclk (boolean) : valid only where PHY do not have quartz and need to be clock
by RCC
Example:
ethernet@40028000 {
compatible = "st,stm32-dwmac", "snps,dwmac-3.50a";
reg = <0x40028000 0x8000>;
reg-names = "stmmaceth";
interrupts = <0 61 0>, <0 62 0>;
interrupt-names = "macirq", "eth_wake_irq";
clock-names = "stmmaceth", "mac-clk-tx", "mac-clk-rx";
clocks = <&rcc 0 25>, <&rcc 0 26>, <&rcc 0 27>;
st,syscon = <&syscfg 0x4>;
snps,pbl = <8>;
snps,mixed-burst;
dma-ranges;
};
|
