diff options
Diffstat (limited to 'Documentation/devicetree/bindings/mfd/rohm,bd71837-pmic.yaml')
| -rw-r--r-- | Documentation/devicetree/bindings/mfd/rohm,bd71837-pmic.yaml | 244 |
1 files changed, 244 insertions, 0 deletions
diff --git a/Documentation/devicetree/bindings/mfd/rohm,bd71837-pmic.yaml b/Documentation/devicetree/bindings/mfd/rohm,bd71837-pmic.yaml new file mode 100644 index 000000000..3bfdd3370 --- /dev/null +++ b/Documentation/devicetree/bindings/mfd/rohm,bd71837-pmic.yaml @@ -0,0 +1,244 @@ +# SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause +%YAML 1.2 +--- +$id: http://devicetree.org/schemas/mfd/rohm,bd71837-pmic.yaml# +$schema: http://devicetree.org/meta-schemas/core.yaml# + +title: ROHM BD71837 Power Management Integrated Circuit bindings + +maintainers: + - Matti Vaittinen <matti.vaittinen@fi.rohmeurope.com> + +description: | + BD71837MWV is programmable Power Management ICs for powering single-core, + dual-core, and quad-core SoCs such as NXP-i.MX 8M. It is optimized for low + BOM cost and compact solution footprint. BD71837MWV integrates 8 Buck + regulators and 7 LDOs. + Datasheet for BD71837 is available at + https://www.rohm.com/products/power-management/power-management-ic-for-system/industrial-consumer-applications/nxp-imx/bd71837amwv-product + +properties: + compatible: + const: rohm,bd71837 + + reg: + description: + I2C slave address. + maxItems: 1 + + interrupts: + maxItems: 1 + + clocks: + maxItems: 1 + + clock-names: + const: osc + + "#clock-cells": + const: 0 + + clock-output-names: + const: pmic_clk + +# The BD718x7 supports two different HW states as reset target states. States +# are called as SNVS and READY. At READY state all the PMIC power outputs go +# down and OTP is reload. At the SNVS state all other logic and external +# devices apart from the SNVS power domain are shut off. Please refer to NXP +# i.MX8 documentation for further information regarding SNVS state. When a +# reset is done via SNVS state the PMIC OTP data is not reload. This causes +# power outputs that have been under SW control to stay down when reset has +# switched power state to SNVS. If reset is done via READY state the power +# outputs will be returned to HW control by OTP loading. Thus the reset +# target state is set to READY by default. If SNVS state is used the boot +# crucial regulators must have the regulator-always-on and regulator-boot-on +# properties set in regulator node. + + rohm,reset-snvs-powered: + description: | + Transfer PMIC to SNVS state at reset + type: boolean + +# Configure the "short press" and "long press" timers for the power button. +# Values are rounded to what hardware supports +# Short-press: +# Shortest being 10ms, next 500ms and then multiple of 500ms up to 7,5s +# Long-press: +# Shortest being 10ms, next 1000ms and then multiple of 1000ms up to 15s +# If these properties are not present the existing configuration (from +# bootloader or OTP) is not touched. + + rohm,short-press-ms: + description: + Short press duration in milliseconds + enum: + - 10 + - 500 + - 1000 + - 1500 + - 2000 + - 2500 + - 3000 + - 3500 + - 4000 + - 4500 + - 5000 + - 5500 + - 6000 + - 6500 + - 7000 + + rohm,long-press-ms: + description: + Long press duration in milliseconds + enum: + - 10 + - 1000 + - 2000 + - 3000 + - 4000 + - 5000 + - 6000 + - 7000 + - 8000 + - 9000 + - 10000 + - 11000 + - 12000 + - 13000 + - 14000 + + regulators: + $ref: ../regulator/rohm,bd71837-regulator.yaml + description: + List of child nodes that specify the regulators. + +required: + - compatible + - reg + - interrupts + - clocks + - "#clock-cells" + - regulators + +additionalProperties: false + +examples: + - | + #include <dt-bindings/interrupt-controller/irq.h> + #include <dt-bindings/leds/common.h> + + i2c { + #address-cells = <1>; + #size-cells = <0>; + pmic: pmic@4b { + compatible = "rohm,bd71837"; + reg = <0x4b>; + interrupt-parent = <&gpio1>; + interrupts = <29 IRQ_TYPE_LEVEL_LOW>; + #clock-cells = <0>; + clocks = <&osc 0>; + rohm,reset-snvs-powered; + rohm,short-press-ms = <10>; + rohm,long-press-ms = <2000>; + + regulators { + buck1: BUCK1 { + regulator-name = "buck1"; + regulator-min-microvolt = <700000>; + regulator-max-microvolt = <1300000>; + regulator-boot-on; + regulator-always-on; + regulator-ramp-delay = <1250>; + rohm,dvs-run-voltage = <900000>; + rohm,dvs-idle-voltage = <850000>; + rohm,dvs-suspend-voltage = <800000>; + }; + buck2: BUCK2 { + regulator-name = "buck2"; + regulator-min-microvolt = <700000>; + regulator-max-microvolt = <1300000>; + regulator-boot-on; + regulator-always-on; + regulator-ramp-delay = <1250>; + rohm,dvs-run-voltage = <1000000>; + rohm,dvs-idle-voltage = <900000>; + }; + buck3: BUCK3 { + regulator-name = "buck3"; + regulator-min-microvolt = <700000>; + regulator-max-microvolt = <1300000>; + regulator-boot-on; + rohm,dvs-run-voltage = <1000000>; + }; + buck4: BUCK4 { + regulator-name = "buck4"; + regulator-min-microvolt = <700000>; + regulator-max-microvolt = <1300000>; + regulator-boot-on; + rohm,dvs-run-voltage = <1000000>; + }; + buck5: BUCK5 { + regulator-name = "buck5"; + regulator-min-microvolt = <700000>; + regulator-max-microvolt = <1350000>; + regulator-boot-on; + }; + buck6: BUCK6 { + regulator-name = "buck6"; + regulator-min-microvolt = <3000000>; + regulator-max-microvolt = <3300000>; + regulator-boot-on; + }; + buck7: BUCK7 { + regulator-name = "buck7"; + regulator-min-microvolt = <1605000>; + regulator-max-microvolt = <1995000>; + regulator-boot-on; + }; + buck8: BUCK8 { + regulator-name = "buck8"; + regulator-min-microvolt = <800000>; + regulator-max-microvolt = <1400000>; + }; + + ldo1: LDO1 { + regulator-name = "ldo1"; + regulator-min-microvolt = <3000000>; + regulator-max-microvolt = <3300000>; + regulator-boot-on; + }; + ldo2: LDO2 { + regulator-name = "ldo2"; + regulator-min-microvolt = <900000>; + regulator-max-microvolt = <900000>; + regulator-boot-on; + }; + ldo3: LDO3 { + regulator-name = "ldo3"; + regulator-min-microvolt = <1800000>; + regulator-max-microvolt = <3300000>; + }; + ldo4: LDO4 { + regulator-name = "ldo4"; + regulator-min-microvolt = <900000>; + regulator-max-microvolt = <1800000>; + }; + ldo5: LDO5 { + regulator-name = "ldo5"; + regulator-min-microvolt = <1800000>; + regulator-max-microvolt = <3300000>; + }; + ldo6: LDO6 { + regulator-name = "ldo6"; + regulator-min-microvolt = <900000>; + regulator-max-microvolt = <1800000>; + }; + ldo7_reg: LDO7 { + regulator-name = "ldo7"; + regulator-min-microvolt = <1800000>; + regulator-max-microvolt = <3300000>; + }; + }; + }; + }; |