1 files changed, 84 insertions, 0 deletions
diff --git a/Documentation/leds/leds-blinkm.rst b/Documentation/leds/leds-blinkm.rst
new file mode 100644
index 000000000..c74b5bc87
--- /dev/null
+++ b/Documentation/leds/leds-blinkm.rst
@@ -0,0 +1,84 @@
+==================
+Leds BlinkM driver
+==================
+
+The leds-blinkm driver supports the devices of the BlinkM family.
+
+They are RGB-LED modules driven by a (AT)tiny microcontroller and
+communicate through I2C. The default address of these modules is
+0x09 but this can be changed through a command. By this you could
+dasy-chain up to 127 BlinkMs on an I2C bus.
+
+The device accepts RGB and HSB color values through separate commands.
+Also you can store blinking sequences as "scripts" in
+the controller and run them. Also fading is an option.
+
+The interface this driver provides is 2-fold:
+
+a) LED class interface for use with triggers
+############################################
+
+The registration follows the scheme::
+
+  blinkm-<i2c-bus-nr>-<i2c-device-nr>-<color>
+
+  $ ls -h /sys/class/leds/blinkm-6-*
+  /sys/class/leds/blinkm-6-9-blue:
+  brightness  device  max_brightness  power  subsystem  trigger  uevent
+
+  /sys/class/leds/blinkm-6-9-green:
+  brightness  device  max_brightness  power  subsystem  trigger  uevent
+
+  /sys/class/leds/blinkm-6-9-red:
+  brightness  device  max_brightness  power  subsystem  trigger  uevent
+
+(same is /sys/bus/i2c/devices/6-0009/leds)
+
+We can control the colors separated into red, green and blue and
+assign triggers on each color.
+
+E.g.::
+
+  $ cat blinkm-6-9-blue/brightness
+  05
+
+  $ echo 200 > blinkm-6-9-blue/brightness
+  $
+
+  $ modprobe ledtrig-heartbeat
+  $ echo heartbeat > blinkm-6-9-green/trigger
+  $
+
+
+b) Sysfs group to control rgb, fade, hsb, scripts ...
+#####################################################
+
+This extended interface is available as folder blinkm
+in the sysfs folder of the I2C device.
+E.g. below /sys/bus/i2c/devices/6-0009/blinkm
+
+  $ ls -h /sys/bus/i2c/devices/6-0009/blinkm/
+  blue  green  red  test
+
+Currently supported is just setting red, green, blue
+and a test sequence.
+
+E.g.::
+
+  $ cat *
+  00
+  00
+  00
+  #Write into test to start test sequence!#
+
+  $ echo 1 > test
+  $
+
+  $ echo 255 > red
+  $
+
+
+
+as of 6/2012
+
+dl9pf <at> gmx <dot> de