blob: 32b3712c916ebd7d4c1a3558d7bdc5184ca99d15 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
|
Bindings for EETI touchscreen controller
Required properties:
- compatible: should be "eeti,exc3000-i2c"
- reg: I2C address of the chip. Should be set to <0xa>
- interrupts: interrupt to which the chip is connected
Optional properties:
- attn-gpios: A handle to a GPIO to check whether interrupt is still
latched. This is necessary for platforms that lack
support for level-triggered IRQs.
The following optional properties described in touchscreen.txt are
also supported:
- touchscreen-inverted-x
- touchscreen-inverted-y
- touchscreen-swapped-x-y
Example:
i2c-master {
touchscreen@a {
compatible = "eeti,exc3000-i2c";
reg = <0xa>;
interrupt-parent = <&gpio>;
interrupts = <123 IRQ_TYPE_EDGE_RISING>;
attn-gpios = <&gpio 123 GPIO_ACTIVE_HIGH>;
};
};
|
