blob: da5d13b16ae2ac398226d737a343b084ed47b71a (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
|
<!--
title: "Adaptec RAID controller monitoring with Netdata"
custom_edit_url: https://github.com/netdata/netdata/edit/master/collectors/python.d.plugin/adaptec_raid/README.md
sidebar_label: "Adaptec RAID"
-->
# Adaptec RAID controller monitoring with Netdata
Collects logical and physical devices metrics using `arcconf` command-line utility.
Executed commands:
- `sudo -n arcconf GETCONFIG 1 LD`
- `sudo -n arcconf GETCONFIG 1 PD`
## Requirements
The module uses `arcconf`, which can only be executed by `root`. It uses
`sudo` and assumes that it is configured such that the `netdata` user can execute `arcconf` as root without a password.
- Add to your `/etc/sudoers` file:
`which arcconf` shows the full path to the binary.
```bash
netdata ALL=(root) NOPASSWD: /path/to/arcconf
```
- Reset Netdata's systemd
unit [CapabilityBoundingSet](https://www.freedesktop.org/software/systemd/man/systemd.exec.html#Capabilities) (Linux
distributions with systemd)
The default CapabilityBoundingSet doesn't allow using `sudo`, and is quite strict in general. Resetting is not optimal, but a next-best solution given the inability to execute `arcconf` using `sudo`.
As the `root` user, do the following:
```cmd
mkdir /etc/systemd/system/netdata.service.d
echo -e '[Service]\nCapabilityBoundingSet=~' | tee /etc/systemd/system/netdata.service.d/unset-capability-bounding-set.conf
systemctl daemon-reload
systemctl restart netdata.service
```
## Charts
- Logical Device Status
- Physical Device State
- Physical Device S.M.A.R.T warnings
- Physical Device Temperature
## Enable the collector
The `adaptec_raid` collector is disabled by default. To enable it, use `edit-config` from the
Netdata [config directory](/docs/configure/nodes.md), which is typically at `/etc/netdata`, to edit the `python.d.conf`
file.
```bash
cd /etc/netdata # Replace this path with your Netdata config directory, if different
sudo ./edit-config python.d.conf
```
Change the value of the `adaptec_raid` setting to `yes`. Save the file and restart the Netdata Agent with `sudo
systemctl restart netdata`, or the [appropriate method](/docs/configure/start-stop-restart.md) for your system.
## Configuration
Edit the `python.d/adaptec_raid.conf` configuration file using `edit-config` from the
Netdata [config directory](/docs/configure/nodes.md), which is typically at `/etc/netdata`.
```bash
cd /etc/netdata # Replace this path with your Netdata config directory, if different
sudo ./edit-config python.d/adaptec_raid.conf
```
---
|
