Adding upstream version 5.10.209.upstream/5.10.209upstream

Signed-off-by: Daniel Baumann <daniel.baumann@progress-linux.org>

1 files changed, 215 insertions, 0 deletions

diff --git a/Documentation/devicetree/bindings/devfreq/rk3399_dmc.txt b/Documentation/devicetree/bindings/devfreq/rk3399_dmc.txt
new file mode 100644
index 000000000..a10d1f6d8
--- /dev/null
+++ b/Documentation/devicetree/bindings/devfreq/rk3399_dmc.txt
@@ -0,0 +1,215 @@
+* Rockchip rk3399 DMC (Dynamic Memory Controller) device
+
+Required properties:
+- compatible:		 Must be "rockchip,rk3399-dmc".
+- devfreq-events:	 Node to get DDR loading, Refer to
+			 Documentation/devicetree/bindings/devfreq/event/
+			 rockchip-dfi.txt
+- clocks:		 Phandles for clock specified in "clock-names" property
+- clock-names :		 The name of clock used by the DFI, must be
+			 "pclk_ddr_mon";
+- operating-points-v2:	 Refer to Documentation/devicetree/bindings/opp/opp.txt
+			 for details.
+- center-supply:	 DMC supply node.
+- status:		 Marks the node enabled/disabled.
+
+Optional properties:
+- interrupts:		 The CPU interrupt number. The interrupt specifier
+			 format depends on the interrupt controller.
+			 It should be a DCF interrupt. When DDR DVFS finishes
+			 a DCF interrupt is triggered.
+- rockchip,pmu:		 Phandle to the syscon managing the "PMU general register
+			 files".
+
+Following properties relate to DDR timing:
+
+- rockchip,dram_speed_bin :	  Value reference include/dt-bindings/clock/rk3399-ddr.h,
+				  it selects the DDR3 cl-trp-trcd type. It must be
+				  set according to "Speed Bin" in DDR3 datasheet,
+				  DO NOT use a smaller "Speed Bin" than specified
+				  for the DDR3 being used.
+
+- rockchip,pd_idle :		  Configure the PD_IDLE value. Defines the
+				  power-down idle period in which memories are
+				  placed into power-down mode if bus is idle
+				  for PD_IDLE DFI clock cycles.
+
+- rockchip,sr_idle :		  Configure the SR_IDLE value. Defines the
+				  self-refresh idle period in which memories are
+				  placed into self-refresh mode if bus is idle
+				  for SR_IDLE * 1024 DFI clock cycles (DFI
+				  clocks freq is half of DRAM clock), default
+				  value is "0".
+
+- rockchip,sr_mc_gate_idle :	  Defines the memory self-refresh and controller
+				  clock gating idle period. Memories are placed
+				  into self-refresh mode and memory controller
+				  clock arg gating started if bus is idle for
+				  sr_mc_gate_idle*1024 DFI clock cycles.
+
+- rockchip,srpd_lite_idle :	  Defines the self-refresh power down idle
+				  period in which memories are placed into
+				  self-refresh power down mode if bus is idle
+				  for srpd_lite_idle * 1024 DFI clock cycles.
+				  This parameter is for LPDDR4 only.
+
+- rockchip,standby_idle :	  Defines the standby idle period in which
+				  memories are placed into self-refresh mode.
+				  The controller, pi, PHY and DRAM clock will
+				  be gated if bus is idle for standby_idle * DFI
+				  clock cycles.
+
+- rockchip,dram_dll_dis_freq :	  Defines the DDR3 DLL bypass frequency in MHz.
+				  When DDR frequency is less than DRAM_DLL_DISB_FREQ,
+				  DDR3 DLL will be bypassed. Note: if DLL was bypassed,
+				  the odt will also stop working.
+
+- rockchip,phy_dll_dis_freq :	  Defines the PHY dll bypass frequency in
+				  MHz (Mega Hz). When DDR frequency is less than
+				  DRAM_DLL_DISB_FREQ, PHY DLL will be bypassed.
+				  Note: PHY DLL and PHY ODT are independent.
+
+- rockchip,ddr3_odt_dis_freq :	  When the DRAM type is DDR3, this parameter defines
+				  the ODT disable frequency in MHz (Mega Hz).
+				  when the DDR frequency is  less then ddr3_odt_dis_freq,
+				  the ODT on the DRAM side and controller side are
+				  both disabled.
+
+- rockchip,ddr3_drv :		  When the DRAM type is DDR3, this parameter defines
+				  the DRAM side driver strength in ohms. Default
+				  value is DDR3_DS_40ohm.
+
+- rockchip,ddr3_odt :		  When the DRAM type is DDR3, this parameter defines
+				  the DRAM side ODT strength in ohms. Default value
+				  is DDR3_ODT_120ohm.
+
+- rockchip,phy_ddr3_ca_drv :	  When the DRAM type is DDR3, this parameter defines
+				  the phy side CA line (incluing command line,
+				  address line and clock line) driver strength.
+				  Default value is PHY_DRV_ODT_40.
+
+- rockchip,phy_ddr3_dq_drv :	  When the DRAM type is DDR3, this parameter defines
+				  the PHY side DQ line (including DQS/DQ/DM line)
+				  driver strength. Default value is PHY_DRV_ODT_40.
+
+- rockchip,phy_ddr3_odt : 	  When the DRAM type is DDR3, this parameter defines
+				  the PHY side ODT strength. Default value is
+				  PHY_DRV_ODT_240.
+
+- rockchip,lpddr3_odt_dis_freq : When the DRAM type is LPDDR3, this parameter defines
+				  then ODT disable frequency in MHz (Mega Hz).
+				  When DDR frequency is less then ddr3_odt_dis_freq,
+				  the ODT on the DRAM side and controller side are
+				  both disabled.
+
+- rockchip,lpddr3_drv :		  When the DRAM type is LPDDR3, this parameter defines
+				  the DRAM side driver strength in ohms. Default
+				  value is LP3_DS_34ohm.
+
+- rockchip,lpddr3_odt :		  When the DRAM type is LPDDR3, this parameter defines
+				  the DRAM side ODT strength in ohms. Default value
+				  is LP3_ODT_240ohm.
+
+- rockchip,phy_lpddr3_ca_drv :	  When the DRAM type is LPDDR3, this parameter defines
+				  the PHY side CA line (including command line,
+				  address line and clock line) driver strength.
+				  Default value is PHY_DRV_ODT_40.
+
+- rockchip,phy_lpddr3_dq_drv :	  When the DRAM type is LPDDR3, this parameter defines
+				  the PHY side DQ line (including DQS/DQ/DM line)
+				  driver strength. Default value is
+				  PHY_DRV_ODT_40.
+
+- rockchip,phy_lpddr3_odt : 	  When dram type is LPDDR3, this parameter define
+				  the phy side odt strength, default value is
+				  PHY_DRV_ODT_240.
+
+- rockchip,lpddr4_odt_dis_freq : When the DRAM type is LPDDR4, this parameter
+				  defines the ODT disable frequency in
+				  MHz (Mega Hz). When the DDR frequency is less then
+				  ddr3_odt_dis_freq, the ODT on the DRAM side and
+				  controller side are both disabled.
+
+- rockchip,lpddr4_drv :		  When the DRAM type is LPDDR4, this parameter defines
+				  the DRAM side driver strength in ohms. Default
+				  value is LP4_PDDS_60ohm.
+
+- rockchip,lpddr4_dq_odt : 	  When the DRAM type is LPDDR4, this parameter defines
+				  the DRAM side ODT on DQS/DQ line strength in ohms.
+				  Default value is LP4_DQ_ODT_40ohm.
+
+- rockchip,lpddr4_ca_odt :	  When the DRAM type is LPDDR4, this parameter defines
+				  the DRAM side ODT on CA line strength in ohms.
+				  Default value is LP4_CA_ODT_40ohm.
+
+- rockchip,phy_lpddr4_ca_drv :	  When the DRAM type is LPDDR4, this parameter defines
+				  the PHY side CA line (including command address
+				  line) driver strength. Default value is
+				  PHY_DRV_ODT_40.
+
+- rockchip,phy_lpddr4_ck_cs_drv : When the DRAM type is LPDDR4, this parameter defines
+				  the PHY side clock line and CS line driver
+				  strength. Default value is PHY_DRV_ODT_80.
+
+- rockchip,phy_lpddr4_dq_drv :	  When the DRAM type is LPDDR4, this parameter defines
+				  the PHY side DQ line (including DQS/DQ/DM line)
+				  driver strength. Default value is PHY_DRV_ODT_80.
+
+- rockchip,phy_lpddr4_odt :	  When the DRAM type is LPDDR4, this parameter defines
+				  the PHY side ODT strength. Default value is
+				  PHY_DRV_ODT_60.
+
+Example:
+	dmc_opp_table: dmc_opp_table {
+		compatible = "operating-points-v2";
+
+		opp00 {
+			opp-hz = /bits/ 64 <300000000>;
+			opp-microvolt = <900000>;
+		};
+		opp01 {
+			opp-hz = /bits/ 64 <666000000>;
+			opp-microvolt = <900000>;
+		};
+	};
+
+	dmc: dmc {
+		compatible = "rockchip,rk3399-dmc";
+		devfreq-events = <&dfi>;
+		interrupts = <GIC_SPI 1 IRQ_TYPE_LEVEL_HIGH>;
+		clocks = <&cru SCLK_DDRCLK>;
+		clock-names = "dmc_clk";
+		operating-points-v2 = <&dmc_opp_table>;
+		center-supply = <&ppvar_centerlogic>;
+		upthreshold = <15>;
+		downdifferential = <10>;
+		rockchip,ddr3_speed_bin = <21>;
+		rockchip,pd_idle = <0x40>;
+		rockchip,sr_idle = <0x2>;
+		rockchip,sr_mc_gate_idle = <0x3>;
+		rockchip,srpd_lite_idle	= <0x4>;
+		rockchip,standby_idle = <0x2000>;
+		rockchip,dram_dll_dis_freq = <300>;
+		rockchip,phy_dll_dis_freq = <125>;
+		rockchip,auto_pd_dis_freq = <666>;
+		rockchip,ddr3_odt_dis_freq = <333>;
+		rockchip,ddr3_drv = <DDR3_DS_40ohm>;
+		rockchip,ddr3_odt = <DDR3_ODT_120ohm>;
+		rockchip,phy_ddr3_ca_drv = <PHY_DRV_ODT_40>;
+		rockchip,phy_ddr3_dq_drv = <PHY_DRV_ODT_40>;
+		rockchip,phy_ddr3_odt = <PHY_DRV_ODT_240>;
+		rockchip,lpddr3_odt_dis_freq = <333>;
+		rockchip,lpddr3_drv = <LP3_DS_34ohm>;
+		rockchip,lpddr3_odt = <LP3_ODT_240ohm>;
+		rockchip,phy_lpddr3_ca_drv = <PHY_DRV_ODT_40>;
+		rockchip,phy_lpddr3_dq_drv = <PHY_DRV_ODT_40>;
+		rockchip,phy_lpddr3_odt = <PHY_DRV_ODT_240>;
+		rockchip,lpddr4_odt_dis_freq = <333>;
+		rockchip,lpddr4_drv = <LP4_PDDS_60ohm>;
+		rockchip,lpddr4_dq_odt = <LP4_DQ_ODT_40ohm>;
+		rockchip,lpddr4_ca_odt = <LP4_CA_ODT_40ohm>;
+		rockchip,phy_lpddr4_ca_drv = <PHY_DRV_ODT_40>;
+		rockchip,phy_lpddr4_ck_cs_drv = <PHY_DRV_ODT_80>;
+		rockchip,phy_lpddr4_dq_drv = <PHY_DRV_ODT_80>;
+		rockchip,phy_lpddr4_odt = <PHY_DRV_ODT_60>;
+	};