Adding upstream version 5.10.209.upstream/5.10.209upstream

Signed-off-by: Daniel Baumann <daniel.baumann@progress-linux.org>

1 files changed, 52 insertions, 0 deletions

diff --git a/Documentation/devicetree/bindings/regulator/max8973-regulator.txt b/Documentation/devicetree/bindings/regulator/max8973-regulator.txt
new file mode 100644
index 000000000..c2c68fcc1
--- /dev/null
+++ b/Documentation/devicetree/bindings/regulator/max8973-regulator.txt
@@ -0,0 +1,52 @@
+* Maxim MAX8973 Voltage Regulator
+
+Required properties:
+
+- compatible:	must be one of following:
+			"maxim,max8973"
+			"maxim,max77621".
+- reg:		the i2c slave address of the regulator. It should be 0x1b.
+
+Any standard regulator properties can be used to configure the single max8973
+DCDC.
+
+Optional properties:
+
+-maxim,externally-enable: boolean, externally control the regulator output
+		enable/disable.
+-maxim,enable-gpio: GPIO for enable control. If the valid GPIO is provided
+		then externally enable control will be considered.
+-maxim,dvs-gpio: GPIO which is connected to DVS pin of device.
+-maxim,dvs-default-state: Default state of GPIO during initialisation.
+		1 for HIGH and 0 for LOW.
+-maxim,enable-remote-sense: boolean, enable reote sense.
+-maxim,enable-falling-slew-rate: boolean, enable falling slew rate.
+-maxim,enable-active-discharge: boolean: enable active discharge.
+-maxim,enable-frequency-shift: boolean, enable 9% frequency shift.
+-maxim,enable-bias-control: boolean, enable bias control. By enabling this
+		startup delay can be reduce to 20us from 220us.
+-maxim,enable-etr: boolean, enable Enhanced Transient Response.
+-maxim,enable-high-etr-sensitivity: boolean, Enhanced transient response
+		circuit is enabled and set for high sensitivity. If this
+		property is available then etr will be enable default.
+
+Enhanced transient response (ETR) will affect the configuration of CKADV.
+
+-junction-warn-millicelsius: u32, junction warning temperature threshold
+		in millicelsius. If die temperature crosses this level then
+		device generates the warning interrupts.
+
+Please note that thermal functionality is only supported on MAX77621. The
+supported threshold warning temperature for MAX77621 are 120 degC and 140 degC.
+
+Example:
+
+	max8973@1b {
+		compatible = "maxim,max8973";
+		reg = <0x1b>;
+
+		regulator-min-microvolt = <935000>;
+		regulator-max-microvolt = <1200000>;
+		regulator-boot-on;
+		regulator-always-on;
+	};