diff options
Diffstat (limited to 'Documentation/devicetree/bindings/iio/humidity/hts221.txt')
| -rw-r--r-- | Documentation/devicetree/bindings/iio/humidity/hts221.txt | 30 |
1 files changed, 30 insertions, 0 deletions
diff --git a/Documentation/devicetree/bindings/iio/humidity/hts221.txt b/Documentation/devicetree/bindings/iio/humidity/hts221.txt new file mode 100644 index 000000000..84d029372 --- /dev/null +++ b/Documentation/devicetree/bindings/iio/humidity/hts221.txt @@ -0,0 +1,30 @@ +* HTS221 STM humidity + temperature sensor + +Required properties: +- compatible: should be "st,hts221" +- reg: i2c address of the sensor / spi cs line + +Optional properties: +- drive-open-drain: the interrupt/data ready line will be configured + as open drain, which is useful if several sensors share the same + interrupt line. This is a boolean property. + If the requested interrupt is configured as IRQ_TYPE_LEVEL_HIGH or + IRQ_TYPE_EDGE_RISING a pull-down resistor is needed to drive the line + when it is not active, whereas a pull-up one is needed when interrupt + line is configured as IRQ_TYPE_LEVEL_LOW or IRQ_TYPE_EDGE_FALLING. + Refer to pinctrl/pinctrl-bindings.txt for the property description. +- interrupts: interrupt mapping for IRQ. It should be configured with + flags IRQ_TYPE_LEVEL_HIGH, IRQ_TYPE_EDGE_RISING, IRQ_TYPE_LEVEL_LOW or + IRQ_TYPE_EDGE_FALLING. + + Refer to interrupt-controller/interrupts.txt for generic interrupt + client node bindings. + +Example: + +hts221@5f { + compatible = "st,hts221"; + reg = <0x5f>; + interrupt-parent = <&gpio0>; + interrupts = <0 IRQ_TYPE_EDGE_RISING>; +}; |