diff options
Diffstat (limited to 'Documentation/devicetree/bindings/rtc/isil,isl1208.txt')
| -rw-r--r-- | Documentation/devicetree/bindings/rtc/isil,isl1208.txt | 38 |
1 files changed, 38 insertions, 0 deletions
diff --git a/Documentation/devicetree/bindings/rtc/isil,isl1208.txt b/Documentation/devicetree/bindings/rtc/isil,isl1208.txt new file mode 100644 index 000000000..51f003006 --- /dev/null +++ b/Documentation/devicetree/bindings/rtc/isil,isl1208.txt @@ -0,0 +1,38 @@ +Intersil ISL1209/19 I2C RTC/Alarm chip with event in + +ISL12X9 have additional pins EVIN and #EVDET for tamper detection, while the +ISL1208 and ISL1218 do not. They are all use the same driver with the bindings +described here, with chip specific properties as noted. + +Required properties supported by the device: + - "compatible": Should be one of the following: + - "isil,isl1208" + - "isil,isl1209" + - "isil,isl1218" + - "isil,isl1219" + - "reg": I2C bus address of the device + +Optional properties: + - "interrupt-names": list which may contains "irq" and "evdet" + evdet applies to isl1209 and isl1219 only + - "interrupts": list of interrupts for "irq" and "evdet" + evdet applies to isl1209 and isl1219 only + - "isil,ev-evienb": Enable or disable internal pull on EVIN pin + Applies to isl1209 and isl1219 only + Possible values are 0 and 1 + Value 0 enables internal pull-up on evin pin, 1 disables it. + Default will leave the non-volatile configuration of the pullup + as is. + +Example isl1219 node with #IRQ pin connected to SoC gpio1 pin12 and #EVDET pin +connected to SoC gpio2 pin 24 and internal pull-up enabled in EVIN pin. + + isl1219: rtc@68 { + compatible = "isil,isl1219"; + reg = <0x68>; + interrupt-names = "irq", "evdet"; + interrupts-extended = <&gpio1 12 IRQ_TYPE_EDGE_FALLING>, + <&gpio2 24 IRQ_TYPE_EDGE_FALLING>; + isil,ev-evienb = <1>; + }; + |