Merging upstream version 6.7.7.

Signed-off-by: Daniel Baumann <daniel.baumann@progress-linux.org>

1 files changed, 0 insertions, 54 deletions

diff --git a/Documentation/devicetree/bindings/hwmon/ina3221.txt b/Documentation/devicetree/bindings/hwmon/ina3221.txt
deleted file mode 100644
index fa63b61714..0000000000
--- a/Documentation/devicetree/bindings/hwmon/ina3221.txt
+++ /dev/null
@@ -1,54 +0,0 @@
-Texas Instruments INA3221 Device Tree Bindings
-
-1) ina3221 node
-  Required properties:
-  - compatible: Must be "ti,ina3221"
-  - reg: I2C address
-
-  Optional properties:
-  - ti,single-shot: This chip has two power modes: single-shot (chip takes one
-                    measurement and then shuts itself down) and continuous (
-                    chip takes continuous measurements). The continuous mode is
-                    more reliable and suitable for hardware monitor type device,
-                    but the single-shot mode is more power-friendly and useful
-                    for battery-powered device which cares power consumptions
-                    while still needs some measurements occasionally.
-                    If this property is present, the single-shot mode will be
-                    used, instead of the default continuous one for monitoring.
-
-  = The node contains optional child nodes for three channels =
-  = Each child node describes the information of input source =
-
-  - #address-cells: Required only if a child node is present. Must be 1.
-  - #size-cells: Required only if a child node is present. Must be 0.
-
-2) child nodes
-  Required properties:
-  - reg: Must be 0, 1 or 2, corresponding to IN1, IN2 or IN3 port of INA3221
-
-  Optional properties:
-  - label: Name of the input source
-  - shunt-resistor-micro-ohms: Shunt resistor value in micro-Ohm
-
-Example:
-
-ina3221@40 {
-	compatible = "ti,ina3221";
-	reg = <0x40>;
-	#address-cells = <1>;
-	#size-cells = <0>;
-
-	input@0 {
-		reg = <0x0>;
-		status = "disabled";
-	};
-	input@1 {
-		reg = <0x1>;
-		shunt-resistor-micro-ohms = <5000>;
-	};
-	input@2 {
-		reg = <0x2>;
-		label = "VDD_5V";
-		shunt-resistor-micro-ohms = <5000>;
-	};
-};