Merging upstream version 6.9.7.

Signed-off-by: Daniel Baumann <daniel.baumann@progress-linux.org>

1 files changed, 0 insertions, 46 deletions

diff --git a/Documentation/devicetree/bindings/regulator/tps65132-regulator.txt b/Documentation/devicetree/bindings/regulator/tps65132-regulator.txt
deleted file mode 100644
index 3a3505520c..0000000000
--- a/Documentation/devicetree/bindings/regulator/tps65132-regulator.txt
+++ /dev/null
@@ -1,46 +0,0 @@
-TPS65132 regulators
-
-Required properties:
-- compatible: "ti,tps65132"
-- reg: I2C slave address
-
-Optional Subnode:
-Device supports two regulators OUTP and OUTN. A sub node within the
-   device node describe the properties of these regulators. The sub-node
-   names must be as follows:
-	-For regulator outp, the sub node name should be "outp".
-	-For regulator outn, the sub node name should be "outn".
-
--enable-gpios:(active high, output) Regulators are controlled by the input pins.
-   If it is connected to GPIO through host system then provide the
-   gpio number as per gpio.txt.
--active-discharge-gpios: (active high, output) Some configurations use delay mechanisms
-  on the enable pin, to keep the regulator enabled for some time after
-  the enable signal goes low. This GPIO is used to actively discharge
-  the delay mechanism. Requires specification of ti,active-discharge-time-us
--ti,active-discharge-time-us: how long the active discharge gpio should be
-  asserted for during active discharge, in microseconds.
-
-Each regulator is defined using the standard binding for regulators.
-
-Example:
-
-	tps65132@3e {
-		compatible = "ti,tps65132";
-		reg = <0x3e>;
-
-		outp {
-			regulator-name = "outp";
-			regulator-boot-on;
-			regulator-always-on;
-			enable-gpios = <&gpio 23 0>;
-		};
-
-		outn {
-			regulator-name = "outn";
-			regulator-boot-on;
-			regulator-always-on;
-			regulator-active-discharge = <0>;
-			enable-gpios = <&gpio 40 0>;
-		};
-	};