Adding upstream version 6.9.9.upstream/6.9.9

Signed-off-by: Daniel Baumann <daniel.baumann@progress-linux.org>

2 files changed, 43 insertions, 29 deletions

diff --git a/drivers/mtd/nand/raw/nand_base.c b/drivers/mtd/nand/raw/nand_base.c
index d7dbbd469b..53e16d39af 100644
--- a/drivers/mtd/nand/raw/nand_base.c
+++ b/drivers/mtd/nand/raw/nand_base.c
@@ -1093,28 +1093,32 @@ static int nand_fill_column_cycles(struct nand_chip *chip, u8 *addrs,
 				   unsigned int offset_in_page)
 {
 	struct mtd_info *mtd = nand_to_mtd(chip);
+	bool ident_stage = !mtd->writesize;
 
-	/* Make sure the offset is less than the actual page size. */
-	if (offset_in_page > mtd->writesize + mtd->oobsize)
-		return -EINVAL;
+	/* Bypass all checks during NAND identification */
+	if (likely(!ident_stage)) {
+		/* Make sure the offset is less than the actual page size. */
+		if (offset_in_page > mtd->writesize + mtd->oobsize)
+			return -EINVAL;
 
-	/*
-	 * On small page NANDs, there's a dedicated command to access the OOB
-	 * area, and the column address is relative to the start of the OOB
-	 * area, not the start of the page. Asjust the address accordingly.
-	 */
-	if (mtd->writesize <= 512 && offset_in_page >= mtd->writesize)
-		offset_in_page -= mtd->writesize;
+		/*
+		 * On small page NANDs, there's a dedicated command to access the OOB
+		 * area, and the column address is relative to the start of the OOB
+		 * area, not the start of the page. Asjust the address accordingly.
+		 */
+		if (mtd->writesize <= 512 && offset_in_page >= mtd->writesize)
+			offset_in_page -= mtd->writesize;
 
-	/*
-	 * The offset in page is expressed in bytes, if the NAND bus is 16-bit
-	 * wide, then it must be divided by 2.
-	 */
-	if (chip->options & NAND_BUSWIDTH_16) {
-		if (WARN_ON(offset_in_page % 2))
-			return -EINVAL;
+		/*
+		 * The offset in page is expressed in bytes, if the NAND bus is 16-bit
+		 * wide, then it must be divided by 2.
+		 */
+		if (chip->options & NAND_BUSWIDTH_16) {
+			if (WARN_ON(offset_in_page % 2))
+				return -EINVAL;
 
-		offset_in_page /= 2;
+			offset_in_page /= 2;
+		}
 	}
 
 	addrs[0] = offset_in_page;
@@ -1123,7 +1127,7 @@ static int nand_fill_column_cycles(struct nand_chip *chip, u8 *addrs,
 	 * Small page NANDs use 1 cycle for the columns, while large page NANDs
 	 * need 2
 	 */
-	if (mtd->writesize <= 512)
+	if (!ident_stage && mtd->writesize <= 512)
 		return 1;
 
 	addrs[1] = offset_in_page >> 8;
@@ -1436,16 +1440,19 @@ int nand_change_read_column_op(struct nand_chip *chip,
 			       unsigned int len, bool force_8bit)
 {
 	struct mtd_info *mtd = nand_to_mtd(chip);
+	bool ident_stage = !mtd->writesize;
 
 	if (len && !buf)
 		return -EINVAL;
 
-	if (offset_in_page + len > mtd->writesize + mtd->oobsize)
-		return -EINVAL;
+	if (!ident_stage) {
+		if (offset_in_page + len > mtd->writesize + mtd->oobsize)
+			return -EINVAL;
 
-	/* Small page NANDs do not support column change. */
-	if (mtd->writesize <= 512)
-		return -ENOTSUPP;
+		/* Small page NANDs do not support column change. */
+		if (mtd->writesize <= 512)
+			return -ENOTSUPP;
+	}
 
 	if (nand_has_exec_op(chip)) {
 		const struct nand_interface_config *conf =
@@ -2173,7 +2180,7 @@ EXPORT_SYMBOL_GPL(nand_reset_op);
 int nand_read_data_op(struct nand_chip *chip, void *buf, unsigned int len,
 		      bool force_8bit, bool check_only)
 {
-	if (!len || !buf)
+	if (!len || (!check_only && !buf))
 		return -EINVAL;
 
 	if (nand_has_exec_op(chip)) {
@@ -6301,6 +6308,7 @@ static const struct nand_ops rawnand_ops = {
 static int nand_scan_tail(struct nand_chip *chip)
 {
 	struct mtd_info *mtd = nand_to_mtd(chip);
+	struct nand_device *base = &chip->base;
 	struct nand_ecc_ctrl *ecc = &chip->ecc;
 	int ret, i;
 
@@ -6445,9 +6453,13 @@ static int nand_scan_tail(struct nand_chip *chip)
 	if (!ecc->write_oob_raw)
 		ecc->write_oob_raw = ecc->write_oob;
 
-	/* propagate ecc info to mtd_info */
+	/* Propagate ECC info to the generic NAND and MTD layers */
 	mtd->ecc_strength = ecc->strength;
+	if (!base->ecc.ctx.conf.strength)
+		base->ecc.ctx.conf.strength = ecc->strength;
 	mtd->ecc_step_size = ecc->size;
+	if (!base->ecc.ctx.conf.step_size)
+		base->ecc.ctx.conf.step_size = ecc->size;
 
 	/*
 	 * Set the number of read / write steps for one page depending on ECC
@@ -6455,6 +6467,8 @@ static int nand_scan_tail(struct nand_chip *chip)
 	 */
 	if (!ecc->steps)
 		ecc->steps = mtd->writesize / ecc->size;
+	if (!base->ecc.ctx.nsteps)
+		base->ecc.ctx.nsteps = ecc->steps;
 	if (ecc->steps * ecc->size != mtd->writesize) {
 		WARN(1, "Invalid ECC parameters\n");
 		ret = -EINVAL;
diff --git a/drivers/mtd/nand/raw/rockchip-nand-controller.c b/drivers/mtd/nand/raw/rockchip-nand-controller.c
index 7baaef69d7..5558044763 100644
--- a/drivers/mtd/nand/raw/rockchip-nand-controller.c
+++ b/drivers/mtd/nand/raw/rockchip-nand-controller.c
@@ -420,13 +420,13 @@ static int rk_nfc_setup_interface(struct nand_chip *chip, int target,
 	u32 rate, tc2rw, trwpw, trw2c;
 	u32 temp;
 
-	if (target < 0)
-		return 0;
-
 	timings = nand_get_sdr_timings(conf);
 	if (IS_ERR(timings))
 		return -EOPNOTSUPP;
 
+	if (target < 0)
+		return 0;
+
 	if (IS_ERR(nfc->nfc_clk))
 		rate = clk_get_rate(nfc->ahb_clk);
 	else