summaryrefslogtreecommitdiffstats
path: root/Documentation/devicetree/bindings/regulator/tps65132-regulator.txt
diff options
context:
space:
mode:
Diffstat (limited to 'Documentation/devicetree/bindings/regulator/tps65132-regulator.txt')
-rw-r--r--Documentation/devicetree/bindings/regulator/tps65132-regulator.txt46
1 files changed, 46 insertions, 0 deletions
diff --git a/Documentation/devicetree/bindings/regulator/tps65132-regulator.txt b/Documentation/devicetree/bindings/regulator/tps65132-regulator.txt
new file mode 100644
index 000000000..3a3505520
--- /dev/null
+++ b/Documentation/devicetree/bindings/regulator/tps65132-regulator.txt
@@ -0,0 +1,46 @@
+TPS65132 regulators
+
+Required properties:
+- compatible: "ti,tps65132"
+- reg: I2C slave address
+
+Optional Subnode:
+Device supports two regulators OUTP and OUTN. A sub node within the
+ device node describe the properties of these regulators. The sub-node
+ names must be as follows:
+ -For regulator outp, the sub node name should be "outp".
+ -For regulator outn, the sub node name should be "outn".
+
+-enable-gpios:(active high, output) Regulators are controlled by the input pins.
+ If it is connected to GPIO through host system then provide the
+ gpio number as per gpio.txt.
+-active-discharge-gpios: (active high, output) Some configurations use delay mechanisms
+ on the enable pin, to keep the regulator enabled for some time after
+ the enable signal goes low. This GPIO is used to actively discharge
+ the delay mechanism. Requires specification of ti,active-discharge-time-us
+-ti,active-discharge-time-us: how long the active discharge gpio should be
+ asserted for during active discharge, in microseconds.
+
+Each regulator is defined using the standard binding for regulators.
+
+Example:
+
+ tps65132@3e {
+ compatible = "ti,tps65132";
+ reg = <0x3e>;
+
+ outp {
+ regulator-name = "outp";
+ regulator-boot-on;
+ regulator-always-on;
+ enable-gpios = <&gpio 23 0>;
+ };
+
+ outn {
+ regulator-name = "outn";
+ regulator-boot-on;
+ regulator-always-on;
+ regulator-active-discharge = <0>;
+ enable-gpios = <&gpio 40 0>;
+ };
+ };