diff options
Diffstat (limited to 'drivers/devfreq/Kconfig')
| -rw-r--r-- | drivers/devfreq/Kconfig | 155 |
1 files changed, 155 insertions, 0 deletions
diff --git a/drivers/devfreq/Kconfig b/drivers/devfreq/Kconfig new file mode 100644 index 0000000000..3c4862a752 --- /dev/null +++ b/drivers/devfreq/Kconfig @@ -0,0 +1,155 @@ +# SPDX-License-Identifier: GPL-2.0-only +menuconfig PM_DEVFREQ + bool "Generic Dynamic Voltage and Frequency Scaling (DVFS) support" + select PM_OPP + help + A device may have a list of frequencies and voltages available. + devfreq, a generic DVFS framework can be registered for a device + in order to let the governor provided to devfreq choose an + operating frequency based on the device driver's policy. + + Each device may have its own governor and policy. Devfreq can + reevaluate the device state periodically and/or based on the + notification to "nb", a notifier block, of devfreq. + + Like some CPUs with CPUfreq, a device may have multiple clocks. + However, because the clock frequencies of a single device are + determined by the single device's state, an instance of devfreq + is attached to a single device and returns a "representative" + clock frequency of the device, which is also attached + to a device by 1-to-1. The device registering devfreq takes the + responsibility to "interpret" the representative frequency and + to set its every clock accordingly with the "target" callback + given to devfreq. + + When OPP is used with the devfreq device, it is recommended to + register devfreq's nb to the OPP's notifier head. If OPP is + used with the devfreq device, you may use OPP helper + functions defined in devfreq.h. + +if PM_DEVFREQ + +comment "DEVFREQ Governors" + +config DEVFREQ_GOV_SIMPLE_ONDEMAND + tristate "Simple Ondemand" + help + Chooses frequency based on the recent load on the device. Works + similar as ONDEMAND governor of CPUFREQ does. A device with + Simple-Ondemand should be able to provide busy/total counter + values that imply the usage rate. A device may provide tuned + values to the governor with data field at devfreq_add_device(). + +config DEVFREQ_GOV_PERFORMANCE + tristate "Performance" + help + Sets the frequency at the maximum available frequency. + This governor always returns UINT_MAX as frequency so that + the DEVFREQ framework returns the highest frequency available + at any time. + +config DEVFREQ_GOV_POWERSAVE + tristate "Powersave" + help + Sets the frequency at the minimum available frequency. + This governor always returns 0 as frequency so that + the DEVFREQ framework returns the lowest frequency available + at any time. + +config DEVFREQ_GOV_USERSPACE + tristate "Userspace" + help + Sets the frequency at the user specified one. + This governor returns the user configured frequency if there + has been an input to /sys/devices/.../userspace/set_freq. + Otherwise, the governor does not change the frequency + given at the initialization. + +config DEVFREQ_GOV_PASSIVE + tristate "Passive" + help + Sets the frequency based on the frequency of its parent devfreq + device. This governor does not change the frequency by itself + through sysfs entries. The passive governor recommends that + devfreq device uses the OPP table to get the frequency/voltage. + +comment "DEVFREQ Drivers" + +config ARM_EXYNOS_BUS_DEVFREQ + tristate "ARM Exynos Generic Memory Bus DEVFREQ Driver" + depends on ARCH_EXYNOS || COMPILE_TEST + select DEVFREQ_GOV_SIMPLE_ONDEMAND + select DEVFREQ_GOV_PASSIVE + select DEVFREQ_EVENT_EXYNOS_PPMU + select PM_DEVFREQ_EVENT + help + This adds the common DEVFREQ driver for Exynos Memory bus. Exynos + Memory bus has one more group of memory bus (e.g, MIF and INT block). + Each memory bus group could contain many memoby bus block. It reads + PPMU counters of memory controllers by using DEVFREQ-event device + and adjusts the operating frequencies and voltages with OPP support. + This does not yet operate with optimal voltages. + +config ARM_IMX_BUS_DEVFREQ + tristate "i.MX Generic Bus DEVFREQ Driver" + depends on ARCH_MXC || COMPILE_TEST + select DEVFREQ_GOV_USERSPACE + help + This adds the generic DEVFREQ driver for i.MX interconnects. It + allows adjusting NIC/NOC frequency. + +config ARM_IMX8M_DDRC_DEVFREQ + tristate "i.MX8M DDRC DEVFREQ Driver" + depends on (ARCH_MXC && HAVE_ARM_SMCCC) || \ + (COMPILE_TEST && HAVE_ARM_SMCCC) + select DEVFREQ_GOV_USERSPACE + help + This adds the DEVFREQ driver for the i.MX8M DDR Controller. It allows + adjusting DRAM frequency. + +config ARM_TEGRA_DEVFREQ + tristate "NVIDIA Tegra30/114/124/210 DEVFREQ Driver" + depends on ARCH_TEGRA_3x_SOC || ARCH_TEGRA_114_SOC || \ + ARCH_TEGRA_132_SOC || ARCH_TEGRA_124_SOC || \ + ARCH_TEGRA_210_SOC || \ + COMPILE_TEST + depends on COMMON_CLK + help + This adds the DEVFREQ driver for the Tegra family of SoCs. + It reads ACTMON counters of memory controllers and adjusts the + operating frequencies and voltages with OPP support. + +config ARM_MEDIATEK_CCI_DEVFREQ + tristate "MEDIATEK CCI DEVFREQ Driver" + depends on ARM_MEDIATEK_CPUFREQ || COMPILE_TEST + select DEVFREQ_GOV_PASSIVE + help + This adds a devfreq driver for MediaTek Cache Coherent Interconnect + which is shared the same regulators with the cpu cluster. It can track + buck voltages and update a proper CCI frequency. Use the notification + to get the regulator status. + +config ARM_RK3399_DMC_DEVFREQ + tristate "ARM RK3399 DMC DEVFREQ Driver" + depends on (ARCH_ROCKCHIP && HAVE_ARM_SMCCC) || \ + (COMPILE_TEST && HAVE_ARM_SMCCC) + select DEVFREQ_EVENT_ROCKCHIP_DFI + select DEVFREQ_GOV_SIMPLE_ONDEMAND + select PM_DEVFREQ_EVENT + help + This adds the DEVFREQ driver for the RK3399 DMC(Dynamic Memory Controller). + It sets the frequency for the memory controller and reads the usage counts + from hardware. + +config ARM_SUN8I_A33_MBUS_DEVFREQ + tristate "sun8i/sun50i MBUS DEVFREQ Driver" + depends on ARCH_SUNXI || COMPILE_TEST + depends on COMMON_CLK + select DEVFREQ_GOV_SIMPLE_ONDEMAND + help + This adds the DEVFREQ driver for the MBUS controller in some + Allwinner sun8i (A33 through H3) and sun50i (A64 and H5) SoCs. + +source "drivers/devfreq/event/Kconfig" + +endif # PM_DEVFREQ |