1 files changed, 20 insertions, 24 deletions

diff --git a/drivers/net/ethernet/intel/ixgbe/ixgbe_main.c b/drivers/net/ethernet/intel/ixgbe/ixgbe_main.c
index dd03b017df..6a3f633406 100644
--- a/drivers/net/ethernet/intel/ixgbe/ixgbe_main.c
+++ b/drivers/net/ethernet/intel/ixgbe/ixgbe_main.c
@@ -2421,7 +2421,7 @@ static int ixgbe_clean_rx_irq(struct ixgbe_q_vector *q_vector,
 	}
 
 	if (xdp_xmit & IXGBE_XDP_REDIR)
-		xdp_do_flush_map();
+		xdp_do_flush();
 
 	if (xdp_xmit & IXGBE_XDP_TX) {
 		struct ixgbe_ring *ring = ixgbe_determine_xdp_ring(adapter);
@@ -2756,7 +2756,6 @@ static void ixgbe_check_overtemp_subtask(struct ixgbe_adapter *adapter)
 {
 	struct ixgbe_hw *hw = &adapter->hw;
 	u32 eicr = adapter->interrupt_event;
-	s32 rc;
 
 	if (test_bit(__IXGBE_DOWN, &adapter->state))
 		return;
@@ -2790,14 +2789,13 @@ static void ixgbe_check_overtemp_subtask(struct ixgbe_adapter *adapter)
 		}
 
 		/* Check if this is not due to overtemp */
-		if (hw->phy.ops.check_overtemp(hw) != IXGBE_ERR_OVERTEMP)
+		if (!hw->phy.ops.check_overtemp(hw))
 			return;
 
 		break;
 	case IXGBE_DEV_ID_X550EM_A_1G_T:
 	case IXGBE_DEV_ID_X550EM_A_1G_T_L:
-		rc = hw->phy.ops.check_overtemp(hw);
-		if (rc != IXGBE_ERR_OVERTEMP)
+		if (!hw->phy.ops.check_overtemp(hw))
 			return;
 		break;
 	default:
@@ -5512,7 +5510,7 @@ static int ixgbe_non_sfp_link_config(struct ixgbe_hw *hw)
 {
 	u32 speed;
 	bool autoneg, link_up = false;
-	int ret = IXGBE_ERR_LINK_SETUP;
+	int ret = -EIO;
 
 	if (hw->mac.ops.check_link)
 		ret = hw->mac.ops.check_link(hw, &speed, &link_up, false);
@@ -5983,13 +5981,13 @@ void ixgbe_reset(struct ixgbe_adapter *adapter)
 	err = hw->mac.ops.init_hw(hw);
 	switch (err) {
 	case 0:
-	case IXGBE_ERR_SFP_NOT_PRESENT:
-	case IXGBE_ERR_SFP_NOT_SUPPORTED:
+	case -ENOENT:
+	case -EOPNOTSUPP:
 		break;
-	case IXGBE_ERR_PRIMARY_REQUESTS_PENDING:
+	case -EALREADY:
 		e_dev_err("primary disable timed out\n");
 		break;
-	case IXGBE_ERR_EEPROM_VERSION:
+	case -EACCES:
 		/* We are running on a pre-production device, log a warning */
 		e_dev_warn("This device is a pre-production adapter/LOM. "
 			   "Please be aware there may be issues associated with "
@@ -7829,10 +7827,10 @@ static void ixgbe_sfp_detection_subtask(struct ixgbe_adapter *adapter)
 	adapter->sfp_poll_time = jiffies + IXGBE_SFP_POLL_JIFFIES - 1;
 
 	err = hw->phy.ops.identify_sfp(hw);
-	if (err == IXGBE_ERR_SFP_NOT_SUPPORTED)
+	if (err == -EOPNOTSUPP)
 		goto sfp_out;
 
-	if (err == IXGBE_ERR_SFP_NOT_PRESENT) {
+	if (err == -ENOENT) {
 		/* If no cable is present, then we need to reset
 		 * the next time we find a good cable. */
 		adapter->flags2 |= IXGBE_FLAG2_SFP_NEEDS_RESET;
@@ -7858,7 +7856,7 @@ static void ixgbe_sfp_detection_subtask(struct ixgbe_adapter *adapter)
 	else
 		err = hw->mac.ops.setup_sfp(hw);
 
-	if (err == IXGBE_ERR_SFP_NOT_SUPPORTED)
+	if (err == -EOPNOTSUPP)
 		goto sfp_out;
 
 	adapter->flags |= IXGBE_FLAG_NEED_LINK_CONFIG;
@@ -7867,8 +7865,8 @@ static void ixgbe_sfp_detection_subtask(struct ixgbe_adapter *adapter)
 sfp_out:
 	clear_bit(__IXGBE_IN_SFP_INIT, &adapter->state);
 
-	if ((err == IXGBE_ERR_SFP_NOT_SUPPORTED) &&
-	    (adapter->netdev->reg_state == NETREG_REGISTERED)) {
+	if (err == -EOPNOTSUPP &&
+	    adapter->netdev->reg_state == NETREG_REGISTERED) {
 		e_dev_err("failed to initialize because an unsupported "
 			  "SFP+ module type was detected.\n");
 		e_dev_err("Reload the driver after installing a "
@@ -7938,7 +7936,7 @@ static void ixgbe_service_timer(struct timer_list *t)
 static void ixgbe_phy_interrupt_subtask(struct ixgbe_adapter *adapter)
 {
 	struct ixgbe_hw *hw = &adapter->hw;
-	u32 status;
+	bool overtemp;
 
 	if (!(adapter->flags2 & IXGBE_FLAG2_PHY_INTERRUPT))
 		return;
@@ -7948,11 +7946,9 @@ static void ixgbe_phy_interrupt_subtask(struct ixgbe_adapter *adapter)
 	if (!hw->phy.ops.handle_lasi)
 		return;
 
-	status = hw->phy.ops.handle_lasi(&adapter->hw);
-	if (status != IXGBE_ERR_OVERTEMP)
-		return;
-
-	e_crit(drv, "%s\n", ixgbe_overheat_msg);
+	hw->phy.ops.handle_lasi(&adapter->hw, &overtemp);
+	if (overtemp)
+		e_crit(drv, "%s\n", ixgbe_overheat_msg);
 }
 
 static void ixgbe_reset_subtask(struct ixgbe_adapter *adapter)
@@ -10922,9 +10918,9 @@ static int ixgbe_probe(struct pci_dev *pdev, const struct pci_device_id *ent)
 	err = hw->mac.ops.reset_hw(hw);
 	hw->phy.reset_if_overtemp = false;
 	ixgbe_set_eee_capable(adapter);
-	if (err == IXGBE_ERR_SFP_NOT_PRESENT) {
+	if (err == -ENOENT) {
 		err = 0;
-	} else if (err == IXGBE_ERR_SFP_NOT_SUPPORTED) {
+	} else if (err == -EOPNOTSUPP) {
 		e_dev_err("failed to load because an unsupported SFP+ or QSFP module type was detected.\n");
 		e_dev_err("Reload the driver after installing a supported module.\n");
 		goto err_sw_init;
@@ -11143,7 +11139,7 @@ skip_sriov:
 
 	/* reset the hardware with the new settings */
 	err = hw->mac.ops.start_hw(hw);
-	if (err == IXGBE_ERR_EEPROM_VERSION) {
+	if (err == -EACCES) {
 		/* We are running on a pre-production device, log a warning */
 		e_dev_warn("This device is a pre-production adapter/LOM. "
 			   "Please be aware there may be issues associated "