1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
|
APM X-Gene Standby GPIO controller bindings
This is a gpio controller in the standby domain. It also supports interrupt in
some particular pins which are sourced to its parent interrupt controller
as diagram below:
+-----------------+
| X-Gene standby |
| GPIO controller +------ GPIO_0
+------------+ | | ...
| Parent IRQ | EXT_INT_0 | +------ GPIO_8/EXT_INT_0
| controller | (SPI40) | | ...
| (GICv2) +--------------+ +------ GPIO_[N+8]/EXT_INT_N
| | ... | |
| | EXT_INT_N | +------ GPIO_[N+9]
| | (SPI[40 + N])| | ...
| +--------------+ +------ GPIO_MAX
+------------+ +-----------------+
Required properties:
- compatible: "apm,xgene-gpio-sb" for the X-Gene Standby GPIO controller
- reg: Physical base address and size of the controller's registers
- #gpio-cells: Should be two.
- first cell is the pin number
- second cell is used to specify the gpio polarity:
0 = active high
1 = active low
- gpio-controller: Marks the device node as a GPIO controller.
- interrupts: The EXT_INT_0 parent interrupt resource must be listed first.
- interrupt-cells: Should be two.
- first cell is 0-N corresponding for EXT_INT_0 to EXT_INT_N.
- second cell is used to specify flags.
- interrupt-controller: Marks the device node as an interrupt controller.
- apm,nr-gpios: Optional, specify number of gpios pin.
- apm,nr-irqs: Optional, specify number of interrupt pins.
- apm,irq-start: Optional, specify lowest gpio pin support interrupt.
Example:
sbgpio: gpio@17001000{
compatible = "apm,xgene-gpio-sb";
reg = <0x0 0x17001000 0x0 0x400>;
#gpio-cells = <2>;
gpio-controller;
interrupts = <0x0 0x28 0x1>,
<0x0 0x29 0x1>,
<0x0 0x2a 0x1>,
<0x0 0x2b 0x1>,
<0x0 0x2c 0x1>,
<0x0 0x2d 0x1>;
interrupt-parent = <&gic>;
#interrupt-cells = <2>;
interrupt-controller;
apm,nr-gpios = <22>;
apm,nr-irqs = <6>;
apm,irq-start = <8>;
};
testuser {
compatible = "example,testuser";
/* Use the GPIO_13/EXT_INT_5 line as an active high triggered
* level interrupt
*/
interrupts = <5 4>;
interrupt-parent = <&sbgpio>;
};
|
