blob: bab998c4179aca3b07372782b9be7de340cb8d45 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
|
# SPDX-License-Identifier: GPL-2.0-only
comment "Texas Instruments drivers"
# TI VIDEO PORT Helper Modules
# These will be selected by VPE and VIP
config VIDEO_TI_VPDMA
tristate
config VIDEO_TI_SC
tristate
config VIDEO_TI_CSC
tristate
# V4L drivers
config VIDEO_TI_CAL
tristate "TI CAL (Camera Adaptation Layer) driver"
depends on VIDEO_DEV
depends on V4L_PLATFORM_DRIVERS
select MEDIA_CONTROLLER
select VIDEO_V4L2_SUBDEV_API
depends on SOC_DRA7XX || ARCH_K3 || COMPILE_TEST
select VIDEOBUF2_DMA_CONTIG
select V4L2_FWNODE
help
Support for the TI CAL (Camera Adaptation Layer) block
found on DRA72X SoC.
In TI Technical Reference Manual this module is referred as
Camera Interface Subsystem (CAMSS).
config VIDEO_TI_CAL_MC
bool "Media Controller centric mode by default"
depends on VIDEO_TI_CAL
default n
help
Enables Media Controller centric mode by default.
If set, CAL driver will start in Media Controller mode by
default. Note that this behavior can be overridden via
module parameter 'mc_api'.
# Mem2mem drivers
config VIDEO_TI_VPE
tristate "TI VPE (Video Processing Engine) driver"
depends on V4L_MEM2MEM_DRIVERS
depends on VIDEO_DEV
depends on SOC_DRA7XX || COMPILE_TEST
select VIDEOBUF2_DMA_CONTIG
select V4L2_MEM2MEM_DEV
select VIDEO_TI_VPDMA
select VIDEO_TI_SC
select VIDEO_TI_CSC
help
Support for the TI VPE(Video Processing Engine) block
found on DRA7XX SoC.
config VIDEO_TI_VPE_DEBUG
bool "VPE debug messages"
depends on VIDEO_TI_VPE
help
Enable debug messages on VPE driver.
config VIDEO_TI_J721E_CSI2RX
tristate "TI J721E CSI2RX wrapper layer driver"
depends on VIDEO_DEV && VIDEO_V4L2_SUBDEV_API
depends on MEDIA_SUPPORT && MEDIA_CONTROLLER
depends on (PHY_CADENCE_DPHY_RX && VIDEO_CADENCE_CSI2RX) || COMPILE_TEST
depends on ARCH_K3 || COMPILE_TEST
select VIDEOBUF2_DMA_CONTIG
select V4L2_FWNODE
help
Support for TI CSI2RX wrapper layer. This just enables the wrapper driver.
The Cadence CSI2RX bridge driver needs to be enabled separately.
source "drivers/media/platform/ti/am437x/Kconfig"
source "drivers/media/platform/ti/davinci/Kconfig"
source "drivers/media/platform/ti/omap/Kconfig"
source "drivers/media/platform/ti/omap3isp/Kconfig"
|
