1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
|
/* SPDX-License-Identifier: GPL-2.0 or MIT */
#ifndef __DRM_PANIC_H__
#define __DRM_PANIC_H__
#include <linux/module.h>
#include <linux/types.h>
#include <linux/iosys-map.h>
#include <drm/drm_device.h>
#include <drm/drm_fourcc.h>
/*
* Copyright (c) 2024 Intel
*/
/**
* struct drm_scanout_buffer - DRM scanout buffer
*
* This structure holds the information necessary for drm_panic to draw the
* panic screen, and display it.
*/
struct drm_scanout_buffer {
/**
* @format:
*
* drm format of the scanout buffer.
*/
const struct drm_format_info *format;
/**
* @map:
*
* Virtual address of the scanout buffer, either in memory or iomem.
* The scanout buffer should be in linear format, and can be directly
* sent to the display hardware. Tearing is not an issue for the panic
* screen.
*/
struct iosys_map map[DRM_FORMAT_MAX_PLANES];
/**
* @width: Width of the scanout buffer, in pixels.
*/
unsigned int width;
/**
* @height: Height of the scanout buffer, in pixels.
*/
unsigned int height;
/**
* @pitch: Length in bytes between the start of two consecutive lines.
*/
unsigned int pitch[DRM_FORMAT_MAX_PLANES];
};
/**
* drm_panic_trylock - try to enter the panic printing critical section
* @dev: struct drm_device
* @flags: unsigned long irq flags you need to pass to the unlock() counterpart
*
* This function must be called by any panic printing code. The panic printing
* attempt must be aborted if the trylock fails.
*
* Panic printing code can make the following assumptions while holding the
* panic lock:
*
* - Anything protected by drm_panic_lock() and drm_panic_unlock() pairs is safe
* to access.
*
* - Furthermore the panic printing code only registers in drm_dev_unregister()
* and gets removed in drm_dev_unregister(). This allows the panic code to
* safely access any state which is invariant in between these two function
* calls, like the list of planes &drm_mode_config.plane_list or most of the
* struct drm_plane structure.
*
* Specifically thanks to the protection around plane updates in
* drm_atomic_helper_swap_state() the following additional guarantees hold:
*
* - It is safe to deference the drm_plane.state pointer.
*
* - Anything in struct drm_plane_state or the driver's subclass thereof which
* stays invariant after the atomic check code has finished is safe to access.
* Specifically this includes the reference counted pointers to framebuffer
* and buffer objects.
*
* - Anything set up by &drm_plane_helper_funcs.fb_prepare and cleaned up
* &drm_plane_helper_funcs.fb_cleanup is safe to access, as long as it stays
* invariant between these two calls. This also means that for drivers using
* dynamic buffer management the framebuffer is pinned, and therefer all
* relevant datastructures can be accessed without taking any further locks
* (which would be impossible in panic context anyway).
*
* - Importantly, software and hardware state set up by
* &drm_plane_helper_funcs.begin_fb_access and
* &drm_plane_helper_funcs.end_fb_access is not safe to access.
*
* Drivers must not make any assumptions about the actual state of the hardware,
* unless they explicitly protected these hardware access with drm_panic_lock()
* and drm_panic_unlock().
*
* Return:
* %0 when failing to acquire the raw spinlock, nonzero on success.
*/
#define drm_panic_trylock(dev, flags) \
raw_spin_trylock_irqsave(&(dev)->mode_config.panic_lock, flags)
/**
* drm_panic_lock - protect panic printing relevant state
* @dev: struct drm_device
* @flags: unsigned long irq flags you need to pass to the unlock() counterpart
*
* This function must be called to protect software and hardware state that the
* panic printing code must be able to rely on. The protected sections must be
* as small as possible. It uses the irqsave/irqrestore variant, and can be
* called from irq handler. Examples include:
*
* - Access to peek/poke or other similar registers, if that is the way the
* driver prints the pixels into the scanout buffer at panic time.
*
* - Updates to pointers like &drm_plane.state, allowing the panic handler to
* safely deference these. This is done in drm_atomic_helper_swap_state().
*
* - An state that isn't invariant and that the driver must be able to access
* during panic printing.
*/
#define drm_panic_lock(dev, flags) \
raw_spin_lock_irqsave(&(dev)->mode_config.panic_lock, flags)
/**
* drm_panic_unlock - end of the panic printing critical section
* @dev: struct drm_device
* @flags: irq flags that were returned when acquiring the lock
*
* Unlocks the raw spinlock acquired by either drm_panic_lock() or
* drm_panic_trylock().
*/
#define drm_panic_unlock(dev, flags) \
raw_spin_unlock_irqrestore(&(dev)->mode_config.panic_lock, flags)
#ifdef CONFIG_DRM_PANIC
void drm_panic_register(struct drm_device *dev);
void drm_panic_unregister(struct drm_device *dev);
#else
static inline void drm_panic_register(struct drm_device *dev) {}
static inline void drm_panic_unregister(struct drm_device *dev) {}
#endif
#endif /* __DRM_PANIC_H__ */
|
