Adding upstream version 6.1.76.upstream/6.1.76

Signed-off-by: Daniel Baumann <daniel.baumann@progress-linux.org>

1 files changed, 40 insertions, 0 deletions

diff --git a/drivers/net/hippi/Kconfig b/drivers/net/hippi/Kconfig
new file mode 100644
index 000000000..46b911bb8
--- /dev/null
+++ b/drivers/net/hippi/Kconfig
@@ -0,0 +1,40 @@
+# SPDX-License-Identifier: GPL-2.0-only
+#
+# HIPPI network device configuration
+#
+
+config HIPPI
+	bool "HIPPI driver support"
+	depends on INET && PCI
+	help
+	  HIgh Performance Parallel Interface (HIPPI) is a 800Mbit/sec and
+	  1600Mbit/sec dual-simplex switched or point-to-point network. HIPPI
+	  can run over copper (25m) or fiber (300m on multi-mode or 10km on
+	  single-mode). HIPPI networks are commonly used for clusters and to
+	  connect to super computers. If you are connected to a HIPPI network
+	  and have a HIPPI network card in your computer that you want to use
+	  under Linux, say Y here (you must also remember to enable the driver
+	  for your HIPPI card below). Most people will say N here.
+
+if HIPPI
+
+config ROADRUNNER
+	tristate "Essential RoadRunner HIPPI PCI adapter support"
+	depends on PCI
+	help
+	  Say Y here if this is your PCI HIPPI network card.
+
+	  To compile this driver as a module, choose M here: the module
+	  will be called rrunner.  If unsure, say N.
+
+config ROADRUNNER_LARGE_RINGS
+	bool "Use large TX/RX rings"
+	depends on ROADRUNNER
+	help
+	  If you say Y here, the RoadRunner driver will preallocate up to 2 MB
+	  of additional memory to allow for fastest operation, both for
+	  transmitting and receiving. This memory cannot be used by any other
+	  kernel code or by user space programs. Say Y here only if you have
+	  the memory.
+
+endif # HIPPI