Adding upstream version 6.1.76.upstream/6.1.76upstream

Signed-off-by: Daniel Baumann <daniel.baumann@progress-linux.org>

1 files changed, 65 insertions, 0 deletions

diff --git a/drivers/net/ethernet/qualcomm/Kconfig b/drivers/net/ethernet/qualcomm/Kconfig
new file mode 100644
index 000000000..a4434eb38
--- /dev/null
+++ b/drivers/net/ethernet/qualcomm/Kconfig
@@ -0,0 +1,65 @@
+# SPDX-License-Identifier: GPL-2.0-only
+#
+# Qualcomm network device configuration
+#
+
+config NET_VENDOR_QUALCOMM
+	bool "Qualcomm devices"
+	default y
+	help
+	  If you have a network (Ethernet) card belonging to this class, say Y.
+
+	  Note that the answer to this question doesn't directly affect the
+	  kernel: saying N will just cause the configurator to skip all
+	  the questions about Qualcomm cards. If you say Y, you will be asked
+	  for your specific card in the following questions.
+
+if NET_VENDOR_QUALCOMM
+
+config QCA7000
+	tristate
+	help
+	  This enables support for the Qualcomm Atheros QCA7000.
+
+config QCA7000_SPI
+	tristate "Qualcomm Atheros QCA7000 SPI support"
+	select QCA7000
+	depends on SPI_MASTER && OF
+	help
+	  This SPI protocol driver supports the Qualcomm Atheros QCA7000.
+
+	  To compile this driver as a module, choose M here. The module
+	  will be called qcaspi.
+
+config QCA7000_UART
+	tristate "Qualcomm Atheros QCA7000 UART support"
+	select QCA7000
+	depends on SERIAL_DEV_BUS && OF
+	help
+	  This UART protocol driver supports the Qualcomm Atheros QCA7000.
+
+	  Currently the driver assumes these device UART settings:
+	    Data bits: 8
+	    Parity: None
+	    Stop bits: 1
+	    Flow control: None
+
+	  To compile this driver as a module, choose M here. The module
+	  will be called qcauart.
+
+config QCOM_EMAC
+	tristate "Qualcomm Technologies, Inc. EMAC Gigabit Ethernet support"
+	depends on HAS_DMA && HAS_IOMEM
+	select CRC32
+	select PHYLIB
+	help
+	  This driver supports the Qualcomm Technologies, Inc. Gigabit
+	  Ethernet Media Access Controller (EMAC). The controller
+	  supports IEEE 802.3-2002, half-duplex mode at 10/100 Mb/s,
+	  full-duplex mode at 10/100/1000Mb/s, Wake On LAN (WOL) for
+	  low power, Receive-Side Scaling (RSS), and IEEE 1588-2008
+	  Precision Clock Synchronization Protocol.
+
+source "drivers/net/ethernet/qualcomm/rmnet/Kconfig"
+
+endif # NET_VENDOR_QUALCOMM