diff options
Diffstat (limited to 'arch/mips/pci/pci-bcm1480.c')
| -rw-r--r-- | arch/mips/pci/pci-bcm1480.c | 255 |
1 files changed, 255 insertions, 0 deletions
diff --git a/arch/mips/pci/pci-bcm1480.c b/arch/mips/pci/pci-bcm1480.c new file mode 100644 index 000000000..db0d4d22d --- /dev/null +++ b/arch/mips/pci/pci-bcm1480.c @@ -0,0 +1,255 @@ +// SPDX-License-Identifier: GPL-2.0-or-later +/* + * Copyright (C) 2001,2002,2005 Broadcom Corporation + * Copyright (C) 2004 by Ralf Baechle (ralf@linux-mips.org) + */ + +/* + * BCM1x80/1x55-specific PCI support + * + * This module provides the glue between Linux's PCI subsystem + * and the hardware. We basically provide glue for accessing + * configuration space, and set up the translation for I/O + * space accesses. + * + * To access configuration space, we use ioremap. In the 32-bit + * kernel, this consumes either 4 or 8 page table pages, and 16MB of + * kernel mapped memory. Hopefully neither of these should be a huge + * problem. + * + * XXX: AT THIS TIME, ONLY the NATIVE PCI-X INTERFACE IS SUPPORTED. + */ +#include <linux/types.h> +#include <linux/pci.h> +#include <linux/kernel.h> +#include <linux/init.h> +#include <linux/mm.h> +#include <linux/console.h> +#include <linux/tty.h> +#include <linux/vt.h> + +#include <asm/sibyte/bcm1480_regs.h> +#include <asm/sibyte/bcm1480_scd.h> +#include <asm/sibyte/board.h> +#include <asm/io.h> + +/* + * Macros for calculating offsets into config space given a device + * structure or dev/fun/reg + */ +#define CFGOFFSET(bus, devfn, where) (((bus)<<16)+((devfn)<<8)+(where)) +#define CFGADDR(bus, devfn, where) CFGOFFSET((bus)->number, (devfn), where) + +static void *cfg_space; + +#define PCI_BUS_ENABLED 1 +#define PCI_DEVICE_MODE 2 + +static int bcm1480_bus_status; + +#define PCI_BRIDGE_DEVICE 0 + +/* + * Read/write 32-bit values in config space. + */ +static inline u32 READCFG32(u32 addr) +{ + return *(u32 *)(cfg_space + (addr&~3)); +} + +static inline void WRITECFG32(u32 addr, u32 data) +{ + *(u32 *)(cfg_space + (addr & ~3)) = data; +} + +int pcibios_map_irq(const struct pci_dev *dev, u8 slot, u8 pin) +{ + if (pin == 0) + return -1; + + return K_BCM1480_INT_PCI_INTA - 1 + pin; +} + +/* Do platform specific device initialization at pci_enable_device() time */ +int pcibios_plat_dev_init(struct pci_dev *dev) +{ + return 0; +} + +/* + * Some checks before doing config cycles: + * In PCI Device Mode, hide everything on bus 0 except the LDT host + * bridge. Otherwise, access is controlled by bridge MasterEn bits. + */ +static int bcm1480_pci_can_access(struct pci_bus *bus, int devfn) +{ + u32 devno; + + if (!(bcm1480_bus_status & (PCI_BUS_ENABLED | PCI_DEVICE_MODE))) + return 0; + + if (bus->number == 0) { + devno = PCI_SLOT(devfn); + if (bcm1480_bus_status & PCI_DEVICE_MODE) + return 0; + else + return 1; + } else + return 1; +} + +/* + * Read/write access functions for various sizes of values + * in config space. Return all 1's for disallowed accesses + * for a kludgy but adequate simulation of master aborts. + */ + +static int bcm1480_pcibios_read(struct pci_bus *bus, unsigned int devfn, + int where, int size, u32 * val) +{ + u32 data = 0; + + if ((size == 2) && (where & 1)) + return PCIBIOS_BAD_REGISTER_NUMBER; + else if ((size == 4) && (where & 3)) + return PCIBIOS_BAD_REGISTER_NUMBER; + + if (bcm1480_pci_can_access(bus, devfn)) + data = READCFG32(CFGADDR(bus, devfn, where)); + else + data = 0xFFFFFFFF; + + if (size == 1) + *val = (data >> ((where & 3) << 3)) & 0xff; + else if (size == 2) + *val = (data >> ((where & 3) << 3)) & 0xffff; + else + *val = data; + + return PCIBIOS_SUCCESSFUL; +} + +static int bcm1480_pcibios_write(struct pci_bus *bus, unsigned int devfn, + int where, int size, u32 val) +{ + u32 cfgaddr = CFGADDR(bus, devfn, where); + u32 data = 0; + + if ((size == 2) && (where & 1)) + return PCIBIOS_BAD_REGISTER_NUMBER; + else if ((size == 4) && (where & 3)) + return PCIBIOS_BAD_REGISTER_NUMBER; + + if (!bcm1480_pci_can_access(bus, devfn)) + return PCIBIOS_BAD_REGISTER_NUMBER; + + data = READCFG32(cfgaddr); + + if (size == 1) + data = (data & ~(0xff << ((where & 3) << 3))) | + (val << ((where & 3) << 3)); + else if (size == 2) + data = (data & ~(0xffff << ((where & 3) << 3))) | + (val << ((where & 3) << 3)); + else + data = val; + + WRITECFG32(cfgaddr, data); + + return PCIBIOS_SUCCESSFUL; +} + +struct pci_ops bcm1480_pci_ops = { + .read = bcm1480_pcibios_read, + .write = bcm1480_pcibios_write, +}; + +static struct resource bcm1480_mem_resource = { + .name = "BCM1480 PCI MEM", + .start = A_BCM1480_PHYS_PCI_MEM_MATCH_BYTES, + .end = A_BCM1480_PHYS_PCI_MEM_MATCH_BYTES + 0xfffffffUL, + .flags = IORESOURCE_MEM, +}; + +static struct resource bcm1480_io_resource = { + .name = "BCM1480 PCI I/O", + .start = A_BCM1480_PHYS_PCI_IO_MATCH_BYTES, + .end = A_BCM1480_PHYS_PCI_IO_MATCH_BYTES + 0x1ffffffUL, + .flags = IORESOURCE_IO, +}; + +struct pci_controller bcm1480_controller = { + .pci_ops = &bcm1480_pci_ops, + .mem_resource = &bcm1480_mem_resource, + .io_resource = &bcm1480_io_resource, + .io_offset = A_BCM1480_PHYS_PCI_IO_MATCH_BYTES, +}; + + +static int __init bcm1480_pcibios_init(void) +{ + uint32_t cmdreg; + uint64_t reg; + + /* CFE will assign PCI resources */ + pci_set_flags(PCI_PROBE_ONLY); + + /* Avoid ISA compat ranges. */ + PCIBIOS_MIN_IO = 0x00008000UL; + PCIBIOS_MIN_MEM = 0x01000000UL; + + /* Set I/O resource limits. - unlimited for now to accommodate HT */ + ioport_resource.end = 0xffffffffUL; + iomem_resource.end = 0xffffffffUL; + + cfg_space = ioremap(A_BCM1480_PHYS_PCI_CFG_MATCH_BITS, 16*1024*1024); + + /* + * See if the PCI bus has been configured by the firmware. + */ + reg = __raw_readq(IOADDR(A_SCD_SYSTEM_CFG)); + if (!(reg & M_BCM1480_SYS_PCI_HOST)) { + bcm1480_bus_status |= PCI_DEVICE_MODE; + } else { + cmdreg = READCFG32(CFGOFFSET(0, PCI_DEVFN(PCI_BRIDGE_DEVICE, 0), + PCI_COMMAND)); + if (!(cmdreg & PCI_COMMAND_MASTER)) { + printk + ("PCI: Skipping PCI probe. Bus is not initialized.\n"); + iounmap(cfg_space); + return 1; /* XXX */ + } + bcm1480_bus_status |= PCI_BUS_ENABLED; + } + + /* turn on ExpMemEn */ + cmdreg = READCFG32(CFGOFFSET(0, PCI_DEVFN(PCI_BRIDGE_DEVICE, 0), 0x40)); + WRITECFG32(CFGOFFSET(0, PCI_DEVFN(PCI_BRIDGE_DEVICE, 0), 0x40), + cmdreg | 0x10); + cmdreg = READCFG32(CFGOFFSET(0, PCI_DEVFN(PCI_BRIDGE_DEVICE, 0), 0x40)); + + /* + * Establish mappings in KSEG2 (kernel virtual) to PCI I/O + * space. Use "match bytes" policy to make everything look + * little-endian. So, you need to also set + * CONFIG_SWAP_IO_SPACE, but this is the combination that + * works correctly with most of Linux's drivers. + * XXX ehs: Should this happen in PCI Device mode? + */ + + bcm1480_controller.io_map_base = (unsigned long) + ioremap(A_BCM1480_PHYS_PCI_IO_MATCH_BYTES, 65536); + bcm1480_controller.io_map_base -= bcm1480_controller.io_offset; + set_io_port_base(bcm1480_controller.io_map_base); + + register_pci_controller(&bcm1480_controller); + +#ifdef CONFIG_VGA_CONSOLE + console_lock(); + do_take_over_console(&vga_con, 0, MAX_NR_CONSOLES-1, 1); + console_unlock(); +#endif + return 0; +} + +arch_initcall(bcm1480_pcibios_init); |