summaryrefslogtreecommitdiffstats
path: root/drivers/parisc/iosapic_private.h
diff options
context:
space:
mode:
Diffstat (limited to 'drivers/parisc/iosapic_private.h')
-rw-r--r--drivers/parisc/iosapic_private.h174
1 files changed, 174 insertions, 0 deletions
diff --git a/drivers/parisc/iosapic_private.h b/drivers/parisc/iosapic_private.h
new file mode 100644
index 000000000..bd8ff4016
--- /dev/null
+++ b/drivers/parisc/iosapic_private.h
@@ -0,0 +1,174 @@
+/* SPDX-License-Identifier: GPL-2.0-or-later */
+/*
+ * Private structs/constants for PARISC IOSAPIC support
+ *
+ * Copyright (C) 2000 Hewlett Packard (Grant Grundler)
+ * Copyright (C) 2000,2003 Grant Grundler (grundler at parisc-linux.org)
+ * Copyright (C) 2002 Matthew Wilcox (willy at parisc-linux.org)
+ */
+
+/*
+** This file is private to iosapic driver.
+** If stuff needs to be used by another driver, move it to a common file.
+**
+** WARNING: fields most data structures here are ordered to make sure
+** they pack nicely for 64-bit compilation. (ie sizeof(long) == 8)
+*/
+
+
+/*
+** Interrupt Routing Stuff
+** -----------------------
+** The interrupt routing table consists of entries derived from
+** MP Specification Draft 1.5. There is one interrupt routing
+** table per cell. N- and L-class consist of a single cell.
+*/
+struct irt_entry {
+
+ /* Entry Type 139 identifies an I/O SAPIC interrupt entry */
+ u8 entry_type;
+
+ /* Entry Length 16 indicates entry is 16 bytes long */
+ u8 entry_length;
+
+ /*
+ ** Interrupt Type of 0 indicates a vectored interrupt,
+ ** all other values are reserved
+ */
+ u8 interrupt_type;
+
+ /*
+ ** PO and EL
+ ** Polarity of SAPIC I/O input signals:
+ ** 00 = Reserved
+ ** 01 = Active high
+ ** 10 = Reserved
+ ** 11 = Active low
+ ** Trigger mode of SAPIC I/O input signals:
+ ** 00 = Reserved
+ ** 01 = Edge-triggered
+ ** 10 = Reserved
+ ** 11 = Level-triggered
+ */
+ u8 polarity_trigger;
+
+ /*
+ ** IRQ and DEVNO
+ ** irq identifies PCI interrupt signal where
+ ** 0x0 corresponds to INT_A#,
+ ** 0x1 corresponds to INT_B#,
+ ** 0x2 corresponds to INT_C#
+ ** 0x3 corresponds to INT_D#
+ ** PCI device number where interrupt originates
+ */
+ u8 src_bus_irq_devno;
+
+ /* Source Bus ID identifies the bus where interrupt signal comes from */
+ u8 src_bus_id;
+
+ /*
+ ** Segment ID is unique across a protection domain and
+ ** identifies a segment of PCI buses (reserved in
+ ** MP Specification Draft 1.5)
+ */
+ u8 src_seg_id;
+
+ /*
+ ** Destination I/O SAPIC INTIN# identifies the INTIN n pin
+ ** to which the signal is connected
+ */
+ u8 dest_iosapic_intin;
+
+ /*
+ ** Destination I/O SAPIC Address identifies the I/O SAPIC
+ ** to which the signal is connected
+ */
+ u64 dest_iosapic_addr;
+};
+
+#define IRT_IOSAPIC_TYPE 139
+#define IRT_IOSAPIC_LENGTH 16
+
+#define IRT_VECTORED_INTR 0
+
+#define IRT_PO_MASK 0x3
+#define IRT_ACTIVE_HI 1
+#define IRT_ACTIVE_LO 3
+
+#define IRT_EL_MASK 0x3
+#define IRT_EL_SHIFT 2
+#define IRT_EDGE_TRIG 1
+#define IRT_LEVEL_TRIG 3
+
+#define IRT_IRQ_MASK 0x3
+#define IRT_DEV_MASK 0x1f
+#define IRT_DEV_SHIFT 2
+
+#define IRT_IRQ_DEVNO_MASK ((IRT_DEV_MASK << IRT_DEV_SHIFT) | IRT_IRQ_MASK)
+
+#ifdef SUPPORT_MULTI_CELL
+struct iosapic_irt {
+ struct iosapic_irt *irt_next; /* next routing table */
+ struct irt_entry *irt_base; /* intr routing table address */
+ size_t irte_count; /* number of entries in the table */
+ size_t irte_size; /* size (bytes) of each entry */
+};
+#endif
+
+struct vector_info {
+ struct iosapic_info *iosapic; /* I/O SAPIC this vector is on */
+ struct irt_entry *irte; /* IRT entry */
+ __le32 __iomem *eoi_addr; /* precalculate EOI reg address */
+ __le32 eoi_data; /* IA64: ? PA: swapped txn_data */
+ int txn_irq; /* virtual IRQ number for processor */
+ ulong txn_addr; /* IA64: id_eid PA: partial HPA */
+ u32 txn_data; /* CPU interrupt bit */
+ u8 status; /* status/flags */
+ u8 irqline; /* INTINn(IRQ) */
+};
+
+
+struct iosapic_info {
+ struct iosapic_info * isi_next; /* list of I/O SAPIC */
+ void __iomem * addr; /* remapped address */
+ unsigned long isi_hpa; /* physical base address */
+ struct vector_info * isi_vector; /* IRdT (IRQ line) array */
+ int isi_num_vectors; /* size of IRdT array */
+ int isi_status; /* status/flags */
+ unsigned int isi_version; /* DEBUG: data fr version reg */
+};
+
+
+
+#ifdef __IA64__
+/*
+** PA risc does NOT have any local sapics. IA64 does.
+** PIB (Processor Interrupt Block) is handled by Astro or Dew (Stretch CEC).
+**
+** PA: Get id_eid from IRT and hardcode PIB to 0xfeeNNNN0
+** Emulate the data on PAT platforms.
+*/
+struct local_sapic_info {
+ struct local_sapic_info *lsi_next; /* point to next CPU info */
+ int *lsi_cpu_id; /* point to logical CPU id */
+ unsigned long *lsi_id_eid; /* point to IA-64 CPU id */
+ int *lsi_status; /* point to CPU status */
+ void *lsi_private; /* point to special info */
+};
+
+/*
+** "root" data structure which ties everything together.
+** Should always be able to start with sapic_root and locate
+** the desired information.
+*/
+struct sapic_info {
+ struct sapic_info *si_next; /* info is per cell */
+ int si_cellid; /* cell id */
+ unsigned int si_status; /* status */
+ char *si_pib_base; /* intr blk base address */
+ local_sapic_info_t *si_local_info;
+ io_sapic_info_t *si_io_info;
+ extint_info_t *si_extint_info;/* External Intr info */
+};
+#endif
+