diff options
Diffstat (limited to 'collectors/python.d.plugin/smartd_log/smartd_log.conf')
| -rw-r--r-- | collectors/python.d.plugin/smartd_log/smartd_log.conf | 25 |
1 files changed, 2 insertions, 23 deletions
diff --git a/collectors/python.d.plugin/smartd_log/smartd_log.conf b/collectors/python.d.plugin/smartd_log/smartd_log.conf index 3fab3f1c0..ab7f45b0f 100644 --- a/collectors/python.d.plugin/smartd_log/smartd_log.conf +++ b/collectors/python.d.plugin/smartd_log/smartd_log.conf @@ -63,28 +63,7 @@ # # Additionally to the above, smartd_log also supports the following: # -# log_path: '/path/to/smartdlogs' # path to smartd log files. Default is /var/log/smartd -# raw_values: yes # enable/disable raw values charts. Enabled by default. -# smart_attributes: '1 2 3 4 44' # smart attributes charts. Default are ['1', '4', '5', '7', '9', '12', '193', '194', '197', '198', '200']. -# exclude_disks: 'PATTERN1 PATTERN2' # space separated patterns. If the pattern is in the drive name, the module will not collect data for it. -# -# ---------------------------------------------------------------------- -# Additional information -# Plugin reads smartd log files (-A option). -# You need to add (man smartd) to /etc/default/smartmontools '-i 600 -A /var/log/smartd/' to pass additional options to smartd on startup -# Then restart smartd service and check /path/log/smartdlogs -# ls /var/log/smartd/ -# CDC_WD10EZEX_00BN5A0-WD_WCC3F7FLVZS9.ata.csv WDC_WD10EZEX_00BN5A0-WD_WCC3F7FLVZS9.ata.csv ZDC_WD10EZEX_00BN5A0-WD_WCC3F7FLVZS9.ata.csv -# -# Smartd APPEND logs at every run. Its NOT RECOMMENDED to set '-i' option below 60 sec. -# STRONGLY RECOMMENDED to create smartd conf file for logrotate -# -# RAW vs NORMALIZED values -# "Normalized value", commonly referred to as just "value". This is a most universal measurement, on the scale from 0 (bad) to some maximum (good) value. -# Maximum values are typically 100, 200 or 253. Rule of thumb is: high values are good, low values are bad. -# -# "Raw value" - the value of the attribute as it is tracked by the device, before any normalization takes place. -# Some raw numbers provide valuable insight when properly interpreted. These cases will be discussed later on. -# Raw values are typically listed in hexadecimal numbers. The raw value has different structure for different vendors and is often not meaningful as a decimal number. +# log_path: '/path/to/smartd_logs' # path to smartd log files. Default is /var/log/smartd +# exclude_disks: 'PATTERN1 PATTERN2' # space separated patterns. If the pattern is in the drive name, the module will not collect data for it. # # ---------------------------------------------------------------------- |